SOLAR VISION LX95 User manual

installation ManUal
LX95 commerciaL soLar Lighting FiXtUre
Solar Vision inc. www.solar-vision.com [e-mail] T. 1-819-729-0450
Revision 3.0
IMPORTANT NOTES:
• Alwaysinstallthelightingxtureonthepolebeforeinstallingthebattery.
• Thelightingxtureshouldneverbehandledwithbatteryinstalledinside.
• Thebatterycompartmentcontainsa“quickconnector”toconnectthebattery,identiedas“BATTERY”.
• The battery compartment also contains two additional wires marked “EXTERNAL SOLAR PANEL *OP-
TIONAL* “. These two wires mustneverbeconnectedtothebattery, they are used when an additional
external solar panel is installed.
STEP 2, 3
STEP 4 STEP 5
Indicatorlights
INSTALLATION
1. Using the supplied 5/16”-18 bolts and hardware,
fasten the battery compartment to the solar module
as indicated on the image #1. Orientation of the battery
box is critical, use the “Door Here” sticker to
conrmorientation.
2. Installthelightingxtureonapolewithanouterdiameterof:
• 127mm (5in) LX95 (square sleeve only on the LX95);
3. Slidethelightingxtureontopofthepole;
4. Use the 1/4”-20 bolt to secure the luminaire to the pole, the drilling
pattern is at the end of this document;
5. Once the light is in place, open the battery box door and insert the
battery. The battery is standing up for the LX95;
6. Make a quick connection with the quick connect cable;
7. A green indicator light indicates that the luminaire is functionnal.
8. Close the battery box door, the installation is now complete.
LEARNING DELAY
The light requires a 24-hour delay to operate properly according to it’s
program.
Image#1(step#1)
P.1/4

installation ManUal
LX95 commerciaL soLar Lighting FiXtUre
Solar Vision inc. www.solar-vision.com inf[email protected]om T. 1-819-729-0450
Revision 3.0
SolarModule
Orientation Period Autonomy losses
South
(≈optimal)
Annual 0%
Summer 0%
Winter 0%
East / West
Annual -17%
Summer -9.8%
Winter -28%
North
Annual -35.8%
Summer -21.6%
Winter -54.8%
ORIENTATION AND AUTONOMY 1.1INSTALLATIONGUIDELINES
Toavoidalossofautonomyandamalfunction:
• The luminaire must be installed horizontally and must never be tilted;
• The luminaire must be installed at the end of the post;
• The luminaire must be installed in an open space with no trees or
structures nearby, this could favour snow accumulation and shading;
• The solar module must be ideally oriented towards the south, other-
wise see table “ORIENTATION AND AUTONOMY”.
Failing to follow these recommendations can result in loss of system per-
formance.
FACTORSAFFECTINGAUTONOMY:
Lack of sunshine, very low ambient temperature, snow accumulation due
to trees or structures nearby, shading due to nearby trees or structures,
solar module orientation (see table), too many unplanned occupancy de-
tections (road, unusual activities and events), sunshine below the monthly
averages, time delay too high on the occupancy sensor.
P.2/4

installation ManUal
LX95 commerciaL soLar Lighting FiXtUre
Solar Vision inc. www.solar-vision.com inf[email protected]om T. 1-819-729-0450
Revision 3.0
1.2STORAGEANDHANDLING:
If you wish to store the luminaire, the battery needs to be recharged before
storing for a period of 15 days or more in order to prevent damage to the
battery. The luminaire must be stored at 20°C room temperature.
Theluminaireshouldneverbemanipulatedwhenthebatteryisin-
side.Usethequickaccessdoortoremovethebatterybeforehan-
dling.
1.3DEEPDISCHARGEPROTECTION
This protection signicantly increases battery lifespan. This protection
also prevents permanent damage to the battery caused by very deep dis-
charges during cold weather. Whenthebatteryreachesa50%stateof
charge, the battery is automatically disconnected from the system
untilit’s stateofchargereaches 85% i.e. about 1 day of sunshine in
summer and about 4 days of sunshine in winter.
1.4PIRSENSORTIMEDELAYFEATURE ADJUSTMENT
Pleasebecareful,thetimedelaytrimpotisafragilecomponent.
The Time Delay (30 seconds to 30 minutes) adjustment trimpot is located
under the lens assembly. The trimpot is accessed easily. Gently unscrew
the lens assembly. Do not remove the thumbscrew collar; it holds the sen-
sorinplaceonthexture. Set the time delay to the desired setting. The
time delay can be set from 30 seconds (fully counterclockwise) to 30 min-
utes (fully clockwise). We recommend not to go over 5 minutes. The time
delay starts when no more presence is detected.
1.5DAY-NIGHTTRANSITION
Thextureusesthesolarpaneltodetectdayandnightperiods.Thenight
transition requires a very low brightness level for 5 continuous minutes.
This constraint prevents false night transitions. Avoid exposing the lumi-
nairetoanarticiallightsourcethatmaycausesynchronizationerrorsby
simulatingtheday.Ifthextureoperateserratically,makesurethesolar
module is not covered with debris or heavy snow. The luminaire auto-
matically corrects synchronization errors after 24 hours. The occupancy
sensor has its own photocell, which does not activate when the ambient
brightness is too high.
P.3/4

B
2.500
1.250 5.125
TYP.
.35
DETAIL
B
SCALE
1 : 3
NOTE: The installation of the lamp on the top of the post requires drilling the post as per the presented drilling patturn. The lamp will be secured using one bolt through the lamp post. The holes should be pointing in the direction of the desired orientation.
DIRECTION OF LIGHTING
REV.
DESCRIPTION
DATE
PAR
1
UPDATE OF THE NOTE
26 MAR 2020
JFOL
A A
B B
2 2
1 1
5 IN POST DRILLING
PATTERN
LX95
1
DO NOT SCALE DRAWING
LX95-02-EN
SHEET 1 OF 1
30 MAY 19
30 MAY 19
JFOL
JFOL
UNLESS OTHERWISE SPECIFIED:
SCALE: 1:5
WEIGHT:
REV
DWG NO.
A
TITTLE
NAME
DATE
PROPRIETARY AND CONFIDENTIAL
Q.A.
MFG APPR.
ENG APPR.
CHECKED
DRAWN
FINISH
MATERIAL
INTERPRET GEOMETRIC TOLERANCING PER:
DIMENSIONS ARE IN INCHES TOLERANCES: ANGULAR:
1
TWO PLACE DECIMAL
0.6"
THREE PLACE DECIMAL
0.31"
HOLES:
0.05"
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SOLAR VISION. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SOLAR VISION IS PROHIBITED.
COMMENT
SIZE
P.4/4