Solid Wood Kitchen Cabinets Wide Wall Cabinet User manual

Assembly Guide
IMPORTANT – Please read prior to installation
Thanks for purchasing a solid oak kitchen cabinet. Before you commence installation, please check the contents of
this package to ensure that all necessary components are included. Please contact us immediately via email if any
parts appear to be missing.
Please ensure that you assemble the goods in a clean, dry area, with plenty of space, and that you have the correct
tools and equipment to hand. We recommend that you read the instructions in full before you commence assembly,
and if necessary, run through the installation procedure without physically assembling any items before you begin.
Only construct one cabinet at a time, and follow the installation stages in order, without modication. During
installation, be careful to keep the relevant ttings for the current cabinet together. Do not over tighten screws, and
ensure that any larger panels are laid at and protected.
Clean the cabinets with a damp cloth, and if necessary a small amount of liquid soap, only. Do not use abrasives.
We provide a full cleaning and aftercare guide on our website, please view this for further information.
800mm - 1200mm Wide Wall Cabinet

Panels
Hardware
1
11 x
1 x 2
2 x 3
1 x 4
1 x 5
3
4
5
1 x 6
6
2 x
2 x
G
H
8 x
8 x
6 x
12 x
A
B
C
4 x D
E
4 x F
25mm
30mm
3
2

1A E
E
Insert and as shown in the diagram
below.
Apply a small drop of
glue to each dowel
before inserting.
2
A
A
E
E
A
E
A
E
2Attach wall hanging unit to top of side
panels and using screws.
H
1D 2
17 33
18
34
2

23
3
4Connect the base panel to the side panel
using the ttings inserted during steps 1 and 2.
Repeat the process for the
top panel
2
3
3
3
3
B
B
B
B
B
Insert as shown ensuring the arrow
marking is pointing towards the outside edge.
3
B
B
B
B

6
5
2
4
Slide the back panel between the grooves
on the inside edge of panels
It is advised that you run a small amount of glue
along the grooves rst.
4
3
2
3
3
6
C
C
Fit support panel using 4 x dowels
and secure with 2 x screws
6E
C

1
B
Connect the opposite side panel as shown
then tighten all ttings
1
2
3
3
7
B
Tighten all ttings by turning in
direction of arrow with a screwdriver.
B

Joining Cabinets
Cabinets should be joined be-
tween each set of hinge holes
on the inside edge of the side
panel as shown in the diagram.
Mark 25mm as a guide on a
3mm diameter drill bit using
masking tape. Drill between
the hinge holes into the cabi-
net side panel (18mm) and
7mm into the next until you
reach the marker. Join the two
cabinets together using the
25mm screws provided C
Fitting Shelves
Push the shelf supports into the
pre-drilled shelf holes then sit the shelf
on top.
Shelves
F
Hinge
Holes
Join
Hole