Solo 372-001 User manual

ASD Adaptor
Installation
Solo 372-001
• Ensure Solo 365 is powered off
• With Solo 365 facing you, remove the cup by aligning the notch on the left hand side arm
and disengage by squeezing the cup and gently easing the cup away from the arm
• Rotate the cup to free it from the other arm
• Fit the ASD adaptor by locating into both
arms. Ensure that the fan symbol is located on
the side of the unit where smoke is emitted.
(LHS when unit is facing the user).
Users should note that using the Solo365 in this conguration is outside the scope of the UL classication
for Solo365. The application has been thoroughly tested independently with all ASD technologies.
www.acornfiresecurity.com
www.acornfiresecurity.com

ASD Adaptor
Testing
400066-2
• Power Solo 365 on
• Select the ‘Delayed Start Mode’ by pressing the
‘function button’ for one second – the status
LEDs will ash orange
• Within 20 seconds ensure Solo365 is located
over the sampling hole on the aspirating pipe to
carry out the test
• Smoke will automatically be generated for 20
seconds indicated by the status LEDs ashing blue
www.acornfiresecurity.com
www.acornfiresecurity.com