–14 –
KP-43HT20C/53HS30C
RM-Y908RM-Y908
3-10.ELECTRICAL ADJUSTMENT BY REMOTE
COMMANDER
3. The SCREEN displays the item being adjusted.
4. Press 1 or 4 on the Remote Commander to select the
adjustment item.
5. Press 3 or 6 on the Remote Commander to change the data.
6. Press 2or 5on the Remote Commander to select the
category.
Every time you press 2(Category up), Service mode changes in
the order as shown below.
2. MEMORY WRITE CONFIRMATION METHOD
1. After adjustment, turn power off with the remote commander.
2. Turn power on and set to Service Mode.
3. Call the adjusted items again and confirm they were adjusted.
By using Remote Commander (RM-Y908),all circuit adjustments
can be made.
NOTE : Test Equipment Required.
1. Pattern Generator (with component outputs)
2. Frequency counter
3. Digital multimeter
4. Audio oscillator
1. METHOD OF SETTING THE SERVICE ADJUSTMENT
MODE
SERVICE MODE PROCEDURE
1. Standby mode. (Power off)
2. DISPLAY !5 !VOL (+) !TV POWER
on the Remote Commander.
(Press each button within a second.)
3. ADJUSTING BUTTONS AND INDICATOR
3D-COMB
2103-1
2103-2
2150P-1
2150P-2
2150P-3
2150D-1
2150D-2
2150D-3
2151
AP
TRUS
OP
ID
DLBY
MID2
ID-1
2150P-4 MID1
CCD
PJE
SNNR
OSD
MID3
MID5
7. If you want to recover the latest values press 0then ENTER to
read the memory.
8. Press MUTING then ENTER to write into memory.
9. Turn power off.
Note: Press 8then ENTER on the Remote Commander to initialize or
turn set off and on to exit.
Note : When the PJE mode is activated, which displays an inter-
nally generated signal, several buttons on the remote com-
mander will have different functions than listed above.
Therefore, when in the PJE mode, refer to page 26 for
button functions.
Data
WSL : XXX
0 0
3D-COMB
NRMD
F / A FLAG : XXXXXXXX
CBA FLAG : XXXXXXXX
SERVICE
TV
Item NO.
Adjustment Item
Category
RM-Y908
MUTING
DISPLAY
Adjustment item up
ENTER
Adjustment item down
VOL (+)
TV POWER ON
Category up
Data up
Data down
Category down
