Sony ICD-BX112 User manual

Guide to Better Sound Recording
4-265-122-01(1)
© 2011 Sony Corporation Printed in China
Read this first
Read this leaet for instructions on how to use the IC
recorder. The leaet explains the following.
How to reduce recording noise
How to record sound in various situations
If you want to learn how to use the IC recorder better,
or if you want to make full use of the IC recorder,
please refer to this leaet.


Recommendations for a trial
recording
The recording environment varies from situation to
situation. The dimensions of a room, the loudness
of speech, or a location near noisy equipment can
make a dierence, etc. The desired sound quality also
diers depending on the purpose of the recording.
Therefore, a trial recording is very useful to avoid
missing an important recording, or to create an
environment to record sound with the ideal quality.
About sound that might be recorded as noise
Sounds that cause noise
The IC recorder may record various sounds other
than voice, and the sounds will be heard as noise.
Sounds that occur when you touch the IC recorder
(touch noise)
Rustling sounds of your clothes (when putting the
IC recorder in your pocket)
Vibration sounds (when putting the IC recorder on
a desk or a piano, etc.)



Noise from air conditioner, projector, PC, etc.
Extra ambient sounds (when recording a lecture or
a lesson)
Breath hitting the microphone when recording
near your mouth (pop noise)
Noise caused when recording in long play
recording mode (“LP” mode, etc.)




To reduce recording noise
Touch noises may be recorded when you touch the
IC recorder during recording. Try to avoid touching
the IC recorder until the recording ends.
Move the IC recorder far from the sound source, or
eliminate the noise.
Select the best recording mode according to the
situation. We recommend you to set the recording
mode to the high-quality mode (“HQ” mode,
“SHQ” mode, etc.) when you are concerned about
ambient noise.
Select the best microphone sensitivity according to
the situation. Please try to lower the setting of the




microphone sensitivity when the ambient sounds
become noise and it is not easy to hear the target
sound.
For details about the settings of the recording mode
and the microphone sensitivity installed on the IC
recorder, refer to the supplied operating instructions.
See “Techniques for Better Recording” on the reverse
side of this paper.

To record a meeting To record a lecture or a lesson
Techniques for Better Recording
The IC recorder allows you to record in a variety of situations. This section introduces easy recording setup for 4
typical scenes.
For better recording and playback
To obtain the best recording results, perform a trial recording in advance.
The IC recorder has a noise cut function. The noise cut function reduces the noise, therefore you can hear the
recorded message more clearly.


To record voice memos or dictation To record in your pocket
Tip for setup
Turn the built-in microphone in the direction of the
sound source to be recorded. Or use a directional
microphone (not supplied).
MODE SHQ (Super high-quality monaural
recording mode)
SENS


Tips for setup
The noise of vibration, etc., transmitted from the desk
can be reduced by putting a handkerchief under the
IC recorder.
Record near the speaker.
MODE SHQ (Super high-quality monaural
recording mode)
SENS



Tips for setup
The rustling noise of your clothes can be reduced by
putting a handkerchief, etc. in your pocket to hold the
IC recorder.
You can use the stereo microphone with shirt-clip (not
supplied) to reduce the noise further.
MODE SP (Standard play monaural
recording mode)
SENS



Tips for setup
When recording, hold the IC recorder beside
your mouth to avoid breathing into the built-in
microphone.
When you record holding the IC recorder in your hand,
please note that the sounds from touching the IC
recorder (touch noise) are not recorded.
MODE SP (Standard play monaural
recording mode)
SENS


