Sordin Share User manual

PM332-01_Manual Sordin Share Repeater Sordin AB, version date: 2021.10.22
Page 1 / 4
Manual Sordin Share Repeater
For use with Sordin Share hearing protectors
Download Sordin SHARE app

PM332-01_Manual Sordin Share Repeater Sordin AB, version date: 2021.10.22
Page 2 / 4
INTRODUCTION
Sordin Share Repeater is a range extension unit for use with a group of Sordin Share hearing protectors.
Key features
•Act as a node in the Dynamic Mesh Communication group with up to 14 team members (15 including the repeater).
•Bluetooth® connection to phone for adjusting settings and communication groups.
•USB-C connection to computer for adjusting settings and communication groups.
Available in following variants
Sordin Share Repeater
Sordin Share Repeater with audio input (for possibility to send voice messages to the intercom group)
COMPLIANCE AND APPROVALS
The product complies with,
Directive 2001/95/EC General Product Safety.
EN IEC 62368-1:2020 / A11:2020
Audio/Video, information and communication technology equipment - Part 1: Safety Requirements.
2014/53/EU Radio Equipment Directive RED
ETSI EN 300 328 V2.1.1, ETSI EN 301 489-1 V2.2.0, ETSI EN 301 489-17 V3.2.0.
EN-55032:2015/AC:2016, CLASS B
Electromagnetic compatibility of multimedia equipment - Emission requirements
EN-55035:2017 / AC1:2019 / A11:2020
Electromagnetic compatibility of multimedia equipment - Immunity requirements
IEC 62479:2010
Assessment of the compliance of low-power electronic and electrical equipment with the basic restrictions related to
human exposure to electromagnetic fields (10 MHz to 300 GHz)
Directive 2011/65/EU RoHS2 Restriction of hazardous substances
Further information and the full text of the EU declaration of conformity is available at the following internet address:
www.sordin.com; search for SHARE.
Registered trademarks
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Sordin AB is under license.
SAFETY
WARNING:
Before you install and operate the product, you must read and understand the safety chapter.
•Use and save these instructions.
•Always shut off power to the circuit before installation work.
•Electrical installation work shall only be carried out by an authorised electrical contractor.
•The product contains electrical components that may cause ignition in flammable or explosive atmospheres. Do not
use in environments where sparks may cause a fire or explosion.
•Do not put the product in storage at temperatures above +55°C and below -20°C.
•Only use the product between temperatures -20°C and +55°C.
•Ensure that the product is not damaged during transportation and use.
•Do not change or remove parts on the product.
•Dispose the product in accordance with national legislation.

PM332-01_Manual Sordin Share Repeater Sordin AB, version date: 2021.10.22
Page 3 / 4
INSTALLATION
WARNING:
Before you install and operate the product, you must read and understand the safety chapter.
The unit is designed to meet IP65 protection class and can be placed outside. To protect the unit and prolong the
service life, place the unit so that it is protected from heavy rain and sunlight.
See pictures (Fig.1) and (Fig.2) on last page.
1. Loosen the cover screws (Fig.1.A) and remove the cover (Fig.1.B).
2. Secure the unit on a wall with suitable screws in all four corners (Fig.2.A).
3. Route the electric cable through the cable gland (Fig.2.B) and tighten firmly.
4. Connect circuit lines according to the marking on the internal power supply (Fig.2.C).
5. Place the cover (Fig.1.A) and tighten the cover screws (Fig.1.B). NOTICE!Make sure that the sealing in the cover is in
correct place before the cover is placed.
OPERATION
Switch ON / OFF
•To turn ON, push the multifunction button (Fig.1.C) for 2 seconds. LED (Fig.1.D) flashes GREEN fast 3 times.
When the unit is ON, the LED flashes GREEN slowly with 3-second interval.
•To turn OFF, push the multifunction button (Fig.1.C) for 2 seconds. LED (Fig.1.D) flashes RED fast 3 times.
NOTICE! In case of a power failure, the unit must be switched ON again to operate. No automatic power up.
Group management and other settings
The unit must be a member of the group to which it shall act as a repeater. It can only support the group it is an active
member in.
Group management and other settings can be made in two ways,
Pair a phone via Bluetooth® and use the Sordin Share app to manage groups and other settings in the unit. The app
can be found on Google Play (for Android) and App Store (for iOS). Use Sordin Share App Guide for instructions.
Connect a computer via the USB-C connector (Fig.1.F) and use the Sordin Share Configuration Tool to manage groups
and other settings in the unit. The unit is switched OFF when connected to a computer and must be switched ON
again to operate. Use Sordin Share Configuration Tool Guide for instructions.
Bluetooth pairing
Push multifunction button (Fig.1.C) for 5 seconds, until LED (Fig.1.D) flashes RED/BLUE.
In your phone, search for Bluetooth devices and select “SNNNNNN” (number marked on the unit, Fig.1.E). If the phone
requires a password, enter: 0000.
Once the Bluetooth pairing is performed it will automatically establish connection next time it is used.
To cancel the pairing process, push the multifunction button (Fig.1.C) for 2 seconds.
If pairing is not completed within 2 minutes, the unit automatically returns to standby.
Audio input
3.5mm audio input (Fig.1.G) (only variant) for connection to computer or other source to send voice messages to the
intercom group.

PM332-01_Manual Sordin Share Repeater Sordin AB, version date: 2021.10.22
Page 4 / 4