
Instructions for the SOTA Bio Tuner, Model BT7 with Ear Clips
The SOTA units are consumer products for general health and well-being • The use, safety or effectiveness of the SOTA units, has not been
approved by any government agency • Results using the SOTA Products will vary for each person • Please note that all purchases of SOTA
Products are deemed to be made in Penticton, BC, Canada.
© 2008 SOTA Instruments Inc. Page 4 of 8 www.sota.com
Tighten the band to secure in place.
Option: If preferred, the unit can be placed in a pocket.
Wet the conductive rubber on the Ear Clips with water.6.
Position one clip on each ear lobe. Place closer to the jaw7.
side of the ear lobe.
Turn the unit ON by turning the ON/OFF switch clockwise.8.
All the lights will ash once, before starting the unit in
Mode 1. If the lights do not come on, the battery may not
be placed correctly.
Gradually turn up the intensity. The current may or may not9.
be felt. If felt, the intensity should be comfortable. See ‘How
It Should Feel’ on page 5.
Change modes by pushing the Mode button. The10. g r e e n light indicates which
Mode is selected and that the timing has started. See Mode information on page
6.
After the 20-minute timed session, the unit will automatically cycle into Sleep11.
Mode and the g r e e n Mode light will ash every 2 seconds.
While in Sleep Mode the battery is still being used. Either reset to continue or12.
turn the unit OFF.
To reset, push the Mode button for another timed session. Before resetting fora.
second timed cycle, wet the Ear Clips again.
To turn the unit OFF, rotate the ON/OFF switch counter clockwise until itb.
clicks. Do not force the ON/OFF switch past its natural stopping point.
Notes:
Ear Clips: The Ear Clips may feel more comfortable with the use of either a
conductive gel or aloe vera gel rather than water.
Changing Modes: When the Mode is changed during a timed session, one of
following will occur depending on when your unit was made: 1) the timing
continues without interruption to complete a session of approximately 20 minutes
or 2) the timing will starts again for a new 20 minute session.
Output: The y e l l o w light can be used to check the output of the unit if the current