SoundGate Simple-fi VWZNAUX1 User manual
VWZNAUX1
www.soundgate.com
Rev 20080404
If you experience problems, call SoundGate Technical Support
Purpose
The SoundGate VWZNAUX1 lets you connect a ZuneTM
digital media player directly to the factory radio in the Audi/
Volkswagen vehicles listed below. The VWZNAUX1 supplies
power, charges your Zune device, and allows for remote control
of all Zune device functions (remote sold separately).
Features
The SoundGate VWZNAUX1 utilizes sophisticated microprocessor control, ultra-reliable
surface-mount construction, and advanced software design to flawlessly integrate with Audi/
Volkswagen audio systems.Your Zune device’s audio can be selected from your factory radio’s
controls.
The VWZNAUX1 works in the following vehicles:
AUDI
A4/S4 1998–2005
A6/S6 1998–2004
A8/S8 1998–2001
Allroad Quattro 2001–2005
TT 2000–2004
VOLKSWAGEN
Beetle 1999–2007
Eurovan 1998–2004
Golf/GTI 1998–2005
Jetta 1998–2004
Passat 1998–2005
2
WARNINGS
Before You Begin
WARNING
DO NOT DISASSEMBLE OR ALTER
Doing so may result in an accident, fire, or electric shock.
Do not block your view
Do not mount product or any added audio/video equipment where it can block your view through the windshield or
block your view of dashboard indicators and displays.
Do not block safety devices
Do not mount product or any added audio/video equipment where it can obstruct the operation of any safety device,
such as the airbag.
Distraction warning
Do not allow product or any added audio/video equipment to distract you while you are driving.
BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Before starting any installation work , wait 90 seconds after turning the ignition switch to the LOCK position and disconnecting the negative (-) terminal
from the battery. The supplemental restraint system (SRS), or airbag(s) is equipped with a backup power source. If installation work is started less than 90
seconds after disconnection of the negative (-) battery terminal, the SRS may deploy. When the negative (-) terminal cable is disconnected from the battery,
the clock and audio systems’ memory may be erased. Before starting installation work, make a record of the clock and audio systems’ memory settings.
When installation is complete, reset the clock and audio systems to their previous settings. Power tilt, power telescopic steering column, power seats, power
mirrors, power shoulder belt anchorage, and other power accessories may or may not be equipped with a memory function; consider keeping a record of
these settings as well.
When installation is complete, readjust the features to their previous settings.
Never use a backup power supply (such as another battery) during installation work in an attempt to avoid losing these memory settings.
CAUTION
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS
Cables or wiring that obstruct or get caught on places such as the steering wheel, shift lever, brake pedals, etc. can
be extremely hazardous.
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST
Moisture or dust may result in product failure.
HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS
The wiring and installation of this product requires special technical skills and experience.
USE ONLY SPECIFIED ACCESSORY PARTS
Use of other than specified parts may damage product internally.
FOLLOW THE OPERATIONAL AND INSTALLATION MANUALS.
YOU SHOULD READ AND FAMILIARIZE YOURSELF THOROUGHLY WITH THE FOLLOWING INFORMATION PRIOR TO
INSTALLING AND USING THIS UNIT. IN ADDITION, YOU MUST CAREFULLY READ AND FOLLOW THE INSTALLATION
SCHEMATICS AND INSTRUCTIONS FOR THE PRODUCT AND THE VEHICLE IN WHICH IT IS BEING INSTALLED. FAILURE
TO FOLLOW INSTALLATION INSTRUCTIONS MAY DAMAGE THE PRODUCT AND THE VEHICLE, WILL VOID THE PRODUCT
WARRANTY, AND MAY VOID THE VEHICLE WARRANTY.
CHECK YOUR LOCAL LAWS
Some States/Provinces or other governmental jurisdictions (such as cities) may have laws that prohibit the operation
of a video screen within the sight of the driver. If you have purchased such a product, you should use the product
only in locations where it is legal to do so, and if you do use the product, set up the screen so it is only visible to
passengers.
TROUBLESHOOTING
Should this product fail to operate properly, please contact your Dealer or SoundGate Technical Support
at 800-256-0808.
3
PRODUCT OVERVIEW
VWZNAUX1 Overview
Optional remote control (available
separately). Allows full control of a
connected Zune device’s functions
Inline fuse. The red wire of the power
connector is fused to protect your Zune
device and vehicle systems. This wire
requires a 12V, 1500mA fuse.
Power connector. Connect black wire to bare-metal
chassis. Connect red wire to a +12V switched (ignition)
power source.
Zune Dock Connector. Connect to ZuneTM
digital media player.
RCA component A/V outputs. Yellow = Video, Red = Audio Right,
White = Audio Left. Connect the audio outputs to the matching locations
of the VWZNAUX1 components on the next page
4
PRODUCT OVERVIEW
VWZNAUX1 Overview
Connect the RCA Left (white) and Right (red)
audio cables (from the component-set on
page 3) to the VWZNAUX1 module.
VWZNAUX1 Module
12-pin Male Connector and Ground Wire. Only one of the
harnesses shown should be used. See the instructions on pages 5–6
for installation details.
8-pin Male Connector and Ground Wire.
Only one of the harnesses below should be
used. See the instructions on pages 5–6 for
installation details.
VWZNAUX1 Harness Option B
VWZNAUX1 Harness Option A
5
INSTALLATION
Installation
BEFORE YOU BEGIN:
Turn the ignition off.1.
Ensure the factory radio is turned off2.
Installation
Gain access to the factory radio’s rear panel. The VWZNAUX1
connects directly to the rear panel of the factory radio. Full or partial
disassembly of the dash will be necessary. If you are unsure of this procedure, please consult
a factory service manual or have the work performed by a mobile electronics specialist. Pay
special attention to warnings or instructions regarding working near airbags, other safety
devices, or security systems.
1
1
Connect the appropriate VWZNAUX1 harness to the factory radio.
The VWZNAUX1 comes with two vehicle-specific harnesses. Carefully
review both harness options on page 4 and compare both harnesses with the connectors on
your factory radio’s rear panel. Use the harness that matches your radio’s connectors. Plug
the male connector of the appropriate VWZNAUX1 harness into the matching location on the
factory radio’s rear panel.
Once you have connected the appropriate VWZNAUX1 harness, you must also connect
the attached black or brown ground wire, regardless of which harness option your vehicle
requires. Connect the black or brown wire to a clean, bare-metal chassis ground. When in
doubt, measure the resistance between potential grounding points and the vehicle battery
using a multimeter. Choose a grounding point with equivalent resistance as other grounded
components in the audio system.
2
2
Assemble the components shown on page 3 and connect them
to the VWZNAUX1 module. Use the diagrams on pages 3 and 4 to
assemble the components that will connect to and control your Zune device.
Power connector wiring. Connect the black wire of the power connector shown on page 3
to a clean, bare-metal chassis ground. When in doubt, measure the resistance between
potential grounding points and the vehicle battery using a multimeter. Choose a grounding
point with equivalent resistance as other grounded components in the audio system. Connect
the red wire to a +12V switched (ignition) power source. This wire requires a 12V, 1500mA
inline fuse. MAKE CERTAIN THAT REPLACEMENT FUSES MATCH THESE SPECIFICATIONS.
3
3
6
INSTALLATION
Installation
Mount all components. Mount the VWZNAUX1 modules behind or
under the dash (mounting hardware not included). Be careful not to
drill into wiring or vehicle mechanisms. You are solely responsible for securely fastening the
VWZNAUX1 in your vehicle. Make certain that wires and cables cannot be damaged by screws,
clips, or sharp, exposed pieces of metal.
Ensure that the Zune dock connector is left in a convenient place for connection to your Zune
device. Plug the Zune dock connector in straight. Do not insert the connector at an angle or
wiggle the connector during insertion.
Please read the Operation section on the following page and test the installation before
reassembling the vehicle dash, trim panels, and audio systems.
4
4
7
OPERATION
Operation
Controlling your Zune device
The VWZNAUX1 will not provide control of your Zune device unless you attach the optional
remote, which is available separately. Please visit www.soundgate.com or your local mobile
audio dealer for details on the VWZNAUX1 remote’s availability.
Activating the VWZNAUX1
Turn on the ignition and factory radio.1.
Ensure that your Zune device is connected and playing audio.2.
Wait several seconds for the factory radio and the VWZNAUX1 to synchronize. Press3.
the CD button on your factory radio.
The factory radio’s display will report Disc 1, Track 1—you should hear audio from your
Zune device through your vehicle’s audio system.
To deactivate the VWZNAUX1 and switch your radio back to its normal mode, simply4.
change the source to AM/FM.
NOTE
If the radio’s display does not switch to CD mode after pressing the CD button and you
do not hear music from your Zune device, turn the radio and ignition off. Disconnect
the VWZNAUX1 harness from the factory radio’s rear panel. Wait 30 seconds, then
reconnect the harness. Repeat steps 1–3 above.
This initialization process, if necessary at all, will only need to be performed during the
initial installation.
Why SoundGate Dealers
have the edge...
The technologies used in today’s
vehicles are as sophisticated as any
laptop computer. At SoundGate we
believe these new technologies are full
of opportunities for mobile electronic
dealers across the nation. We make it a
high priority to not only research these
new systems, but to understand them
and their impact on the aftermarket
car audio industry. Armed with this
knowledge, we are well equipped to
help you integrate new components
into these systems with our innovative,
high-performance interfaces and
unparalleled technical support.
Be sure to ask your
autosound specialist
about these other
exciting SoundGate
products...
Auxiliary Input Interfaces and•
Docking Stations which allow
you to input audio from MP3
Players, DVD/Video, Satellite
Radio, and more to OEM and
aftermarket car audio systems
High-performance Radio•
Replacement
Interfaces for seamlessly•
integrating new receivers or CD
players into OEM audio systems
Competition-Grade Interfaces•
for adding amplifiers
Remote Audio Control Interfaces•
that let you control aftermarket
receivers and CD players from
your factory rear seat, or steering-
wheel mounted audio controls.
And many others!•
Copyright© 2004-2008 SoundGate®. All Rights
Reserved. SoundGate® is a registered trademark
of Stillwater Designs, Inc. All other trademarks are
the property of their respective owners.
www.soundgate.com
Zune™ and the Zune™ logo are trademarks of
the Microsoft group of companies.
Table of contents
Other SoundGate Adapter manuals
