SoundMax SM-CCR3187FB User manual

SM-CCR3187FB
USB/SD media player
Instruction manual
USB/SD-медиаплеер
Руководство по эксплуатации
MIC
CLK MUTE
/MODE
BND/
AMS 1/ 2/INT
3/RPT 4/RDM SD
REST
USB
AUX
5/-10 6/+10
SM-CCR3187FB 4 x 45W

2
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully
before connecting, operating and/or adjusting the product and keep the manual for reference in the future.
Table of contents
TABLE OF CONTENTS ......................................................................................................................................................2
IMPORTANT SAFEGUARDS ............................................................................................................................................3
ACCESSORIES....................................................................................................................................................................4
INSTALLATION/CONNECTION......................................................................................................................................5
CONTROL ELEMENTS.......................................................................................................................................................9
GENERAL OPERATIONS ..................................................................................................................................................10
RADIO OPERATIONS........................................................................................................................................................12
USB/SD OPERATIONS .....................................................................................................................................................13
TROUBLESHOOTING GUIDE..........................................................................................................................................15
SPECIFICATION .................................................................................................................................................................16

3
Important safeguards
Read carefully through this manual to familiarize yourself with this high-quality sound system.
The beginning of operation is the moment of the unit installation. Before use the device in winter it is
recommended to heat up the passenger compartment during 20 seconds or to the operation temperature.
Use the unit with the temperature that goes beyond the operation temperature greatly decreases the
operation resource of the screen and other components of device and can result an outage.
Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.
When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher
amperage rating may cause serious damage to the unit.
Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or
create safety hazards such as electrical shock.
Do not use the unit in places where it can be exposed to water, moisture and dust.
Do not open covers and do not repair yourself. Consult the dealer or an experienced technician for help.
Make sure you disconnect the power supply and aerial if you will not be using the system for a long period
or during a thunderstorm.
Make sure you disconnect the power supply if the system appears to be working incorrectly, is making an
unusual sound, has a strange smell, has smoke emitting from it or liquids have got inside it. Have a
qualified technician check the system.
The unit is designed for negative terminal of the battery, which is connected to the vehicle metal. Please
confirm it before installation.
Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it may
overload or burn out the power amplifier.

4
Accessories
1 pc
1 pc
2 pcs
1 pc
1 pc
1. Receiver
2. Mounting parts:
Mounting sleeve
Release keys
3. 12-pin connector
4. Instruction manual

5
Installation/Connection
General notes
Choose the mounting location where the unit will not interfere with the normal driving function of the
driver.
Before finally installing the unit, connect the wiring and make sure that the unit works properly.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the
vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or
from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
DIN FRONT-MOUNT
1. Car dashboard
2. Sleeve
1. Install the sleeve into the dashboard; ensure it is installed with the correct side and there are no
obstacles (wires, dashboard elements, etc) for the unit installation.
2. After installing the sleeve into the dashboard, bend tabs fitting to the size of the dashboard to fix the
sleeve in place.
2
1
182
53

6
3. Make the necessary wire connections. Ensure the connections are correct.
4. Install the unit into the sleeve until the side locks are fixed.
Dismantling the unit
1. Make sure the ignition is turned off, then disconnect the cable from the
vehicle battery’s negative (-) terminal.
2. Insert both of the supplied keys into the slots at the middle left and right
sides of the unit, then pull the unit out of the dashboard.

7
Connection diagram
Notes:
In spite of having any kinds of speaker systems, they must use 4 ohms speaker impedance to reduce
the distortion at high volume levels.
Do not let the auto antenna and ground wires touch each other.

8
Control elements
1.⏭/ (Next/Answer) button
2. VOL/SEL knob
3. Microphone
4. Display
5. USB port
6. AUX IN jack
7. Reset button (hole)
8. SD card slot
9. 6/+10 button
10. 5/-10 button
11. 4/RDM button
12. 3/RPT button
13. 2/INT button
14. 1/⏯ (Play/Pause) button
15. BND/AMS button
16. MUTE button
17. CLK button
18. ⏮/ (Previous/Hang Up) button
19. ⏻ (Power)/MODE button
MIC
CLK MUTE
/MODE
BND/
AMS 1/ 2/INT
3/RPT 4/RDM SD
REST
USB
AUX
5/-10 6/+10
SM-CCR3187FB 4 x 45W
1 2 3 4 5
6
789101112131415161718
19

9
General operations
Turning the unit on/off
Press the Power button to turn the unit on. Press the button again to turn the unit off.
Reset the unit
When first using the device or after replacing the car battery, you must reset the unit. Press the RESET
button (hole) with a pointed object (such as a ballpoint pen) to set the unit to its initial state.
When some errors occur, you can also press the RST button to return to factory settings, but note that it
will erase clock setting and some memorized functions.
Mode selection
Press the MODE button repeatedly to select between Radio => SD/MMC => USB => AUX IN => BT
modes. Operation modes are indicated on the display. SD/MMC and USB modes are not available unless a
memory card or a USB device is connected.
Volume control
Adjust the volume by rotating the VOLUME knob. Mute the sound by pressing the MUTE button.
Audio parameter setting
Press the SEL/VOL knob repeatedly to select a parameter: Volume => BASS => TREBLE => BAL
(balance) => EQ (equalizer) => LOUD OFF/ON (Loudness). Rotate the SEL/VOL knob to adjust
each mode.

10
Loudness
Activating this feature will enhance bass and treble frequencies when listening to music at low volumes.
AUX input
AUX-in jack is intended for connecting an external audio equipment to amplify the sound. If connection is
made correctly, the audio signal from the external source will be transmitted through the acoustics of the
head unit. This enables to adjust the volume and quality of the sounding. For example, you can connect an
MP3-player to listen to tracks using the car acoustic system.
Time display
Press the CLK button to show the current time on the display.
In this mode press and hold the CLK button again. The time will start to flash. Rotate the knob to select
the current hour, press the regulator once to confirm and go to minutes setting, set the minutes in the
same way and press the SEL/VOL knob to confirm.
• Bass/Treble: from -7 to +7;
• Balance: -7 (left) to +7 (right);
• Loudness: see “Loudness” paragraph below
• EQ: select POP/ROCK/JAZZ/CLASS/COUNTRY/6/7/8/9/10 or OFF equalizer mode.
When equalizer is in any mode except OFF, bass and treble are not adjustable.