International Badminton Posts
Visit www.scsport.com.au for your local dealer Revision 2.0 –10.5.16
Assembly:
1. Insert the grooved net cable cap (1) into the slider section (2).
2. Insert the slider section (2) into the upright assembly (4) and insert the tension bolt
(3) and tighten as required.
3. Insert bottom protective cap (9) into the end of the upright assembly (4)
4. Slide the upright assembly (4) onto the end of the stem attached to the weighted base
(6).
5. Insert base connection bolt (5) and tighten up as firmly as possible.
6. Position wheels (7) on back of base, and secure with nut and bolt (8)
Additional Operation Instructions
Position posts on court in required positions.
Secure net to back of one post, and run net cable across the grooved cap to the opposite post.
Run net cable over grooved cap, and tie off on back of post
Adjust net so it is centered between posts, and tie off net cables into place
Note fine adjustment of the net height is possible be adjusting the slider section (2). Release
tension on the tension bolt (3) and adjust as required.
GENERAL MAINTENANCE
Inspect this equipment for wear, loose bolts, damage and proper stability before each use.
Replace defective or worn parts immediately.
WARRANTY
Thisproduct is warrantedto be freefromallmanufacturing defects for a periodof 24 monthsfrom date of
original invoice. All moving and mechanical components, are warranted to be free of manufacturing
defects for a period of 12 months from date of original invoice. All nets, pads and other accessories are
warranted to be free of manufacturing defects for a period of 12 months from date of original purchase.
Normal wearorequipment failure due to misuse or lack of proper maintenance will void all warranties.