Speedtech Scip Hand Remote STHR-4 User manual

SCip Hand Remote
STHR-4
Installation guide
For use with:
Universal Receiver
SCDTM series
SCD miniTM series
Extended battery life
Two way communication
Wide operating temperature span
Shock proof protective rubber enclosure
™

I N T R O D U C T I O N & B A T T E R Y R E P L A C E M E N T
The Hand RemoteTM is a wireless remote control developed for the
purpose of controlling industrial doors and gates. Special attention has
been made regarding current consumption which makes this remote
control last very long in between battery replacements.
Because Hand RemoteTM is sold without batteries a new set will be
required prior to pairing and use.
To insert new batteries remove the blue protective rubber cover, then
open the battery lid as shown below.
Close the lid, install the protective boot and go to...
..Next page:
Pair the Hand Remote with a Universal Receiver (STUR-1)
or
..Back page:
Pair the Hand Remote to a Speed Commander Door (SCD/SCD Mini)

A D D T O A U N I V E R S A L R E C E I V E R
Repeat the below steps to add the
Hand Remote to a Universal Receiver:
For pairing with a SCD/SCD
mini
- See next page 
For further information
please refer to the Universal
Receiver manual.

A D D TO A S C D OR S C D M I N I
Repeat the below steps
to add Hand Remote 4
to a SCD eller SCD mini
Technical data:
Wireless range (indoor):
15m
Network type/frequency:
2.4GHz ISM band
Temperature range:
-20 to +40°C
Power supply:
Battery powered, 2 x 1.5V (size AA/FR6)
NEMA IP rating:
21
Dimensions:
With protection boot:
72.39 x 117.60 x 25.40 mm
Without protection boot:
117.60 x 72.14 x 25.40 mm
Weight:
136g
91g
For further information
about functionality etc.
please refer to the
SCD / SCD Mini
installation guide.
This product is designed and assembled by Speed Tech A/S in Denmark