SPIETH America SHINOBI User guide

ASSEMBLY AND CARE INSTRUCTIONS
SHINOBI TRAINING MULTI-FUNCTIONAL MONKEY BAR
355-170B
VERSION: 8920123 (Revised 08/17)
SALES AND SERVICE
spiethamerica.com
Canada and International
135 Forestview Road, Oro-Medonte
Orillia, Ontario, Canada L3V 0R4
Toll-Free: [phone]
Telephone: [phone]
Fax: [phone]
[email protected]
USA
3327 Ranger Road
Lansing, MI 48906
Toll-Free: [phone]
Telephone: [phone]
Fax: [phone]
[email protected]

355-170B SHINOBI TRAINING MULTI-FUNCTIONAL MONKEY BAR Assembly Instructions
Page 2 of 5
Please read the following instructions carefully before assembling and using your new equipment, as
they pertain to the particular Apparatus you have purchased.
The exclamation mark symbol when seen in this booklet is used to indicate warnings or
items that require special attention during the use or assembly of the apparatus.
Assembly, set-up and adjustment of this equipment should only be undertaken by
qualified persons. At no time should children or other unqualified persons undertake the
assembly, set-up, installation or adjustment of this equipment.
The Spieth America Just for Kids Line is designed and intended for use by beginner
level gymnasts under a weight of 150 lbs (68 kg).
The assembly of this apparatus requires 2 qualified people.
Tools Required:
One 9/16-inch and one 5/8-inch spanner wrench or two small adjustable wrenches.
1. Assembly Instructions
1. Insert the two upright posts over the two chrome tubes of the base, making sure the Snap Lock
pin locks into the same hole position on both sides.
2. Lay the upright posts flat on the floor, with the short round connecting tubes facing up.
3. Hold the monkey bar ladder vertically and place the ladder ends on the upright connecting tubes
on the uprights. Note that the rail cradles will rest on the JFK unit, so make sure they face down
when assembling the ladder and uprights.
4. Bolt the uprights and the ladder together using the 9/16 bolts, lock washers and nuts. Note that
the bolt head should be on the outside of the ladder and the lock washer and round head nut on
the inside.
5. Once the uprights and ladder are assembled, stand up the assembly so that the rail cradles rest
on the Just for Kids Horizontal Bar.
6. Secure the Just for Kids Monkey Bar assembly to the Just for Kids Horizontal bar by wrapping the
Velcro straps around the rail and the cradles.
7. Adjust height using the adjusting holes and spin snap lock. To release the spin snap lock, turn the
red knob counter clockwise completely, then pull the silver pin out to disengage it from the hole.
Set height, make sure the pin is fully engaged in a hole, then turn the red knob clockwise to
secure clamp.
8. Make sure to check assembly by cautiously applying weight to the ladder.
This apparatus must only be used in the horizontal position. Do not use the ladder on an
inclined position. This will put excess stress on the connections and may cause permanent
damage to your apparatus.

355-170B SHINOBI TRAINING MULTI-FUNCTIONAL MONKEY BAR Assembly Instructions
Page 3 of 5
2. Optional set-up: double Monkey Bar and Ninja Holds

355-170B SHINOBI TRAINING MULTI-FUNCTIONAL MONKEY BAR Assembly Instructions
Page 4 of 5

355-170B SHINOBI TRAINING MULTI-FUNCTIONAL MONKEY BAR Assembly Instructions
Page 5 of 5
3. SAFETY
WARNING
Any activity involving motion or height creates the possibility of serious injury including
permanent paralysis and even death from landing or falling on the neck, head or other parts of
the body.
You assume the risk of serious injury in using this equipment. However, the risk can be
reduced by strictly following these rules at all times.
1. This equipment is designed and intended for use only by the beginner level gymnasts
under a weight of 150 lbs (68 kg).
2. Use this equipment only under the supervision of a trained and qualified instructor.
3. This equipment must be used only when protected by proper matting as recommended by
the Federation of International Gymnastics (F.I.G.). If in doubt, concerning proper matting,
do not use this equipment.
4. This equipment must be used with proper spotting equipment and qualified spotters
suitable to the activity or skill. Always consult an instructor.
5. Know your own limitations and the limitations of this equipment. Follow progressive learning
techniques and always consult an instructor.
6. Always inspect this equipment for proper stability before each use.
7. Always inspect this equipment for loose fittings and parts. Replace any worn, defective or
missing parts.
8. Always inspect this equipment for improper or unsafe installation. If in doubt, do not use
this equipment.