
Instructions
Informational Lights & Troubleshooting
SECURE LID & PLACE IN CUP HOLDER
Fill to Max line with fresh, room temp, water. Secure the lid and place Smart
Tumbler in vehicle cup holder. Open the Smart Tumbler tablet packet and
place the tablet at in the tablet holder - DO NOT PRESS DOWN
Remove lid and fill with
fresh water to fill line
Secure lid
Place in cup holder
Place tablet in tablet holder
Checklist
Turn fans on high
Start car
Open all vents
Put system on recirculate
Close windows
Checklist
Light ring turns green
Press and hold red start
button
Release button
Yellow light begins
Checklist
Exit the vehicle
Yellow light appears -
count down begins
15 minute cycle begins
Checklist
Open doors
Light ring turns solid green
Air out for 5 minutes
Checklist
1
START CAR & TURN ON AIR
Start the vehicle, turn fans on high and open all vents, put system on
recirculate, set temperature of vehicle to 77F, and close windows.
Allow car to warm to temperature.
2
PRESS START
Press and hold the red start button until the light ring turns green and
release the button. A 10 second yellow countdown will begin.
3
LEAVE CAR & LET SMART TUMBLER WORK
When the 10 second yellow countdown begins, exit the vehicle. The
tablet will drop into the water and the light ring will turn red and spin
and the 15-minute cycle will begin.
4
OPEN THE DOORS & AIR OUT
At the end of the cycle, the light ring will turn solid green. Open the
doors and allow the vehicle to air out for 5 minutes.
5
Problems?
smarttumbler.com
(855) 221-4855
Solid Red: Tablet Error
Solid Purple: Battery Charging 1, 2, or 3 Red Lights: Low Battery
Solid Blue: Battery Level
Insert tablet correctly (flat) in tablet holder
Each light is % of battery (Half=50%) Charge the unit using plug - full purple lights
Each light is % of battery (Half=50%)
PROBLEM TRY THIS
Unit won’t power on? Charge battery overnight
Red solid light when starting cycle? Add tablet flat in tablet holder
Red solid light after yellow countdown? Stop cycle and check for jam in tablet holder
Odor still in vehicle? Charge to 100% and add fresh water
It’s still not working? Charge the unit using wall power