HUSKY LINERS 6582 Manual

6582 Front_Back.doc
12/08/2004
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your
new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work
well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR LEXUS
RX-330 SECOND SEAT FLOOR LINER
YOUR LEXUS RX 330 COMES STANDARD WITH AN ADJUSTABLE LENGTH CONSOLE. BY MOVING THE
CONSOLE, YOU CAN INCREASE/DECREASE THE SECOND SEAT PASSENGERS’ FLOOR SPACE AS WELL
AS FRONT PASSENGERS’ STORAGE SPACE. YOUR HUSKY LINER IS DESIGNED TO ACCOMMODATE THE
MOVEMENT OF THE CONSOLE SHOULD YOU DECIDE TO ADJUST IT.
IN ITS ORIGINAL (OUT OF THE BOX) CONFIGURATION, YOUR HUSKY LINER FITS WITH THE CONSOLE
ADJUSTED TO THE MOST FORWARD POSITION. THIS POSITION ALLOWS THE MAXIMUM SECOND SEAT
PASSENGER’S FLOOR SPACE; HOWEVER, THE CONSOLE CANNOT BE ADJUSTED TO THE REAR TO
ALLOW FOR MORE FRONT PASSENGER STORAGE. TO ALLOW FOR REARWARD MOVEMENT OF THE
CONSOLE, YOUR HUSKY LINER MUST BE TRIMMED. THE NECESSARY TRIMMING IS EASILY DONE;
DETAILED PHOTOS OF THE NECESSARY TRIMMING ARE INCLUDED ON THE REVERSE SIDE OF THIS
INSTRUCTION SHEET.
FRONT OF VEHICLE

6582 Front_Back.doc
12/08/2004
PHOTO 1
PART #6582 SHOWN “UNTRIMMED” IN PHOTO 1 AND “TRIMMED” IN PHOTO 2. TRIM BY FOLLOWING THE
EDGE FORMED BY THE LOWERED AREA IN THE PART THEN (SEE INSET PHOTOS) CONTINUING ALONG
THE INTERSECTION OF THE WALL AS SHOWN BELOW. ONCE THE WALL IS TRIMMED AWAY, THE
CONSOLE WILL SLIDE OVER THE REMAINING TREAD PLATED AREA.
PHOTO 2