Spinera ISUP User manual

OWNERS MANUAL ISUP
INFLATABLE STAND UP PADDLE BOARD
Thank you for choosing SPINERA. Before using your new product, please take a minute to
read the following warning and safety information. This manual is intended to alert you to
potential hazards that may occur in all water sports.

SAFETY
Paddle Sports can be dangerous. The user of this product acknowledges, understands and assumes
the risks involved in paddle sports. The user must observe the warning labels and safety standards!
WARNING
For your own safety and that of your equipment, make sure to read the entire manual. Failure to
follow the warning notices and instructions may result in property damage, serious injury or death.

WARNING
Use of this product and participation in the sport involves inherent risks of injury or death. To
reduce risks:
Use of this product and participation in the sport involves inherent risks of injury or death. To
reduce risks:
Working pressure: 15 psi
This product does not protect against drowning.
Only for swimmers.
Always wear a properly fitted EN ISO 12402-5 approved personal flotation device or any
equivalent approved vest. This product is not a personal flotation device.
Always read User´s Manual before use.
Fully inflate air chamber
Save distance to shore 150 m
For max. 1 Person with a maximum weight like indicated for this product.
Do not use in wild water
Never use in breaking waves, riptide, river rapids, thunderstorms or lighting conditions
Never use this product in offshore current.
Never use this product in offshore wind conditions.
Not for children 14 years of age and below
If you are under the age of 18, you must have a legal guardian read these warnings and safety
precautions. Do not use this product without adult supervision.
Always supervise children in water
Don´t dive under the Board.
Always use extreme caution when using this product. Never act in a careless manner when
using this product. Misuse of this product may result in serious injury or death.
Only use this product if you are in good physical health, and know how to swim.
You are responsible for you own safety and the safety of others around you when using product
Before using this product, the user should take lessons from a certified school. This product
should not be used by anyone who is not experienced with Stand-up Paddling
Never use this product without a proper surf leash. A loose Stand-up board in water is
extremely dangerous to you, and everyone around you. Failure to use a surf leash may result in
serious injury or death.
Check your equipment prior to each use for signs of wear, leaks or failure and replace it if you
see any sign of wear.
Do not use this product under the influence of alcohol, drugs or medication
Always paddle with an experienced partner when using this product.
Always observe all applicable watercraft laws, Coast Guard rules and regulations when using
this product, and use common sense.
Never use this product in more than 10 knots of wind. Using this product in windy conditions
may result in serious injury or death.
Use caution: Carrying the board in windy conditions may result in serious injury or death
Never use this product near other boat traffic, or watercrafts
In case you sell the ISUP, please hand the manual over to the new owner.
Use at your own risk!

SETTING UP YOUR ISUP
Choose a smooth and clean surface to unfold your board.
-INFLATE
Make sure that the valve is free of sand or dirt. Unscrew the valve cap. Push button in and turn it
anticlockwise to the left, so that it pops out and is in the "OUT" position.
Connect the pump nozzle into the valve and turn it clockwise. Make sure the pump hose is connected
to the ‘Inflate’ outlet.
Before undertaking a long paddle, inflate the board for a full 24 hours to make sure the board is
airtight. When paddling, the colder temperature of the water may cause a slight loss in chamber
pressure. It is good to carry a pump with you.
Maximum air pressure for this product is 15 psi. Do not use an air compressor.
WARNING: Damage to your board caused by over inflation is not covered by your Warranty.

-INSTALL THE SLIDE IN CENTER FIN
Once the board is inflated, install the center fin. Slide the fin into the slot backwards and secure the
fin with the clip (“Click”)
-TIGHTEN THE VALVE
The valve is a service point which has to be tightened before first use
and 1-2 times during the season. There might be a slight release from
transport, lapping of the waves etc.
-PADDLE SIZE
Perfect paddle size: 15-20cm over your head

-DEFLATION STEPS
-Make sure that the valve is free of sand or dirt. Unscrew the valve cap. Slowly press down the
button on the valve to start letting the air out of the board. There will be an initial burst of
air, but that will slow down quickly. Push button in and turn it clockwise to the right, and lock
into "DOWN" position.
-Remove the Clip of the Center Fin and remove the center Fin by sliding forward
BOARD CARE AND STORAGE
-Do not leave the board in the direct sun or in the hot car. If the board is going to be in warm
environment, slightly underinflate the board and put it in the shadow.
WARNING: Damage to your board caused by over inflation or due to extreme conditions is
not covered by your Warranty.
-Remove sand, dirt and salt water after use. Do not use aggressive or abrasive cleaning
products. Most dirt can be removed only with fresh water or mild soap and fresh water. The
Board may only be rolled together. Always remove the fin! To avoid mildew buildup let the
board completely dry before storage. Please roll up only in dry and clean condition! Pay
attention to the correct rolling direction when packing always roll towards the valve
storage. Use the enclosed bag for storage. You may also store the Board inflated. Hanging
the Board is not recommended. Do not store in extreme conditions. Store in a clean and dry
place.
FINDING AND FIXING LEAKS
The PVC is highly durable. In case of puncture or minor damage, the PVC is very easy to repair.
If your board is losing pressure, not due to cold temperatures, check the board leaks. First tightly
close the Valve. We recommend mixing soap and water in a bottle and sprinkling it over the closed
valve. If there is still a leak please follow “Replace the Valve”
If the board is leaking air and the valve is all right, you could have a small puncture. Sprinkle the
board with soapy water until you see bubbles appear and mark the position of the puncture.
-Punctures measuring less than 3 mm you can fix without patch. Deflate your board, then
clean and dry the area. Apply a drop of PVC glue (we recommend Seamseal) to cover the
puncture and let it dry for approximately 12 hours.

-Small repairs: Small leaks such as cuts or holes up to about 12 mm can be repaired with a
round patch with a diameter of about 76mm.We advise you to buy a 2-component pvc
glue. Use the enclosed PVC patches of your repair kit and follow the instructions of the pvc
glue.
-Major repairs: Please contact your dealer!
REMOVING OR REPLACING THE PUMP VALVE
First make sure that the board is fully deflated and without fin.
- Remove the protective cap from the valve
- Turn the valve anticlockwise to loosen the outer part by a couple of
turns and then continue to unscrew it by hand. Before screwing it on
again, it is recommended to apply a small amount of silicone grease
or vaseline to help seal valve again. This product should also be
applied to the black ring on the outer valve to ensure it is properly
sealed.
- Make sure there are no particles of sand or other foreign bodies in
any part of the valve, as this could damage the parts of the valve and
increase the chance of leaks. Screw the valve back on using only your
hands to connect the outer valve on the inner valve. Then use the
special tool to tighten it. Make sure you do not tighten it too much, as
this could damage the valve and reduce its ability to withstand air
pressure.
Limited Warranty 12 month: The warranty for this product is only granted if it is used
properly and for its purpose! Point of Sports GmbH is not liable for damages resulting from
improper use. This warranty does not include: DAMAGE DUE TO EXCESSIVE PUMPING,
CRACKING, CUTTING, HOLES and CUTS CAUSED DURING NORMAL USE, products
involved in ACCIDENTS, products used in RENTAL or COMMERCIAL USE, damages
caused by IMPROPER STRENGTH or IMPROPER USE, BLEACHING by UV radiation. For
warranty claims, please contact your dealer!