Spinmaster Easyspin RF360 User manual

Problem Management Engineering Pty Ltd, 2017
[phone]
6 Kookaburra Road, Hornsby Heights NSW 2077
[e-mail]
pmeautoconversions.com.au
MVRL 30140
Easyspin RF360 User Guide
The RF360 is designed with the user in mind. Any desired custom switch combination is available to suit
the individual and their vehicle.
RF-360 Default setup
DReft indicator BRight indicator
A
Windscreen
wiper
C Flash/High beam
G AUX
F
Horn
A) Press once to activate intermittent wipers
Second Press to activate low speed wipers
Third Press to activate high speed wipers (optional)
Press once more to cancel wipers. When wipers are cancelled you will hear two ‘beeps’
Hold to activate windscreen washer jets.
B) Press to activate right indicator. This will self cancel once you have completed your manoeuver.
During lane changing manoeuvers you may need to cancel the indicator manually by pressing the button again.
C) Short Press to ash the high beams on your vehicle.
Long Press to toggle your high beams on. Long press again to deavtivate.
D) Press to activate left indicator. This will self cancel once you have completed your manoeuver.
During lane changing manoeuvers you may need to cancel the indicator manually by pressing the button again.
E) Press to activate your vehicles horn.
G) Auxiliary button can be programmed for various functions please speak to your installer about the functionality
of this button.

Problem Management Engineering Pty Ltd, 2017
[phone]
6 Kookaburra Road, Hornsby Heights NSW 2077
[e-mail]
pmeautoconversions.com.au
MVRL 30140
Programming and Battery Replacement
Battery
your RF360 Easyspin is designed using the latest circuitry and micro components. This should give
you 2 years of normal use without changing the battery. However under some circumstances the
battery may go at before then. If the battery is running low the red transmission light will blink
intermittently without pressing any buttons. It is recommended that you replace the battery
immediately. If the RF360 stops working it is likely that the battery is completely at.
To replace the battery follow the instructions below.
1) Remove battery tray by using your nger nail to pull on the cutout and release the locking
mechanism
2) Pull the battery tray clear of the RF360 housing being careful not to completely remove
the tray as it is connected to the RF360 housing by two small wires.
3) Remove the at battery and replace with a new 12V 23AE-C5 battery.
4) Reassemble in reverse order.
Programming your RF360 Easyspin.
To change the button conguration, simply press and hold any two buttons for 10 seconds. This will swap the
function of the two buttons pressed. The indicator light will illuminate momentarily to conrm that the buttons
functions have been swapped
Example
Transmission Light
Right indicator
Left Indicator
Highbeam
Wipers
Right indicator Highbeam
Wipers
Left Indicator
Left Indicator
Right indicator
Highbeam
Wipers

Problem Management Engineering Pty Ltd, 2017
[phone]
6 Kookaburra Road, Hornsby Heights NSW 2077
[e-mail]
pmeautoconversions.com.au
MVRL 30140
A
Installation and Removal of RF360
Your RF360 has been designed to be removed from the
Steering wheel clamp when not in use.
To Remove
Hold the red button ‘A’ on the steering wheel clamp
and pull on the RF360 at the same time.
To Reinstall
Hold down the red button ‘A’ on the steering wheel clamp
and insert the shaft of the RF360 into the steering wheel
clamp at the same time.
Caring for your Easyspin RF360
Cleaning
Do not wash your RF360 in water! Use a slightly damp cloth to wipe it clean. Cleaning products
such as Windex can be used, but do not spray directly on to the RF360. Spray onto the cloth and
then wipe the RF360 with the cloth.
Direct Sunlight
When parking in direct sunlight during summer temperatures can exceed 70 degrees. Although
not required, it is recommended that you remove the RF360 when parking in situations such as
this, and store it in the glove box or out of direct sunlight.
PME can not be held responsible for any damages or injury caused by incorrect use of the Easyspin RF360.
Please ensure your license is endorsed for use of this adaptive device. If you are unsure please contact your local motor authority.
It is imperative that during routine maintenance or whenever your vehicle is operated by a driver who is not endorsed to use this
adaptive device; the RF360 easyspin is removed from the steering wheel clamp and stowed safely in the vehicle.