Spirit Commercial CT900 TV BRACKET User manual

CT900 TV BRACKET
INSTALLATION GUIDE

Spirit Fitness

www.spirittness.com
Congratulations on your new TV bracket and welcome to the Spirit Fitness family!
Thank you for your purchase of this TV bracket from Spirit Fitness. This bracket was manufactured by one of
the leading tness manufacturers in the world and is backed by one of the most comprehensive warranties
available. Through your dealer, Spirit Fitness will do all we can to make your ownership experience as pleasant
as possible for many years to come. If not purchased direct from Spirit Fitness, the local dealership where you
purchased this bracket is your administrator for all Spirit Fitness warranty and service needs. Their responsibility
is to provide you with the technical knowledge and service personnel to make your experience more informed
and any difculties easier to remedy.
Please take a moment at this time to record the name of the dealer, their telephone number, and the date of
purchase below to make any future, needed contact easy. We appreciate your support and we will always
remember that you are the reason that we are in business. Please complete and mail your registration card
today.
Yours in Health,
Spirit Fitness
NAME OF DEALER _____________________________________
DEALER PHONE # _____________________________________
PURCHASE DATE _____________________________________

Spirit Fitness
WARNING:
This product may contain a chemical known to the state of California to cause cancer, birth defects, or
other reproductive harm.

5
www.spirittness.com
CT900 T V BRACKET STEP ONE
1. To route the TV cable, rst remove the
TV bracket cover behind the console,
and the outer right side hand rail
cover, and the lower right side
console mast cover.

6
Spirit Fitness
CT900 T V BRACKET STEP TWO
1. Using the TV cable wire, or a wire snake, route
the cables (indicated by thick black line) from the
rear opening under the console toward the right
side (left when facing the rear of the machine)
and out of the console covers near the top of the
right console mast.
2. Run the cables through the large hole in the top
of the console mast until it exits the bottom of the
console mast.

7
www.spirittness.com
1. Raise the incline of the machine to 15 percent to
make this next step easier. Route the cables from
the bottom of the console mast along the bottom
of the treadmill frame to the pivot point of the
incline frame.
2. Run the cables down the incline frame towards
the transportation wheel and then along the
bottom horizontal rail of the frame and tie it off
at about the center of the rail. Add tie wraps to
secure the cables along the incline frame and
under-carriage of the treadmill.
CT900 T V BRACKET STEP THREE

8
Spirit Fitness
CT900 T V BRACKET STEP FOUR
1. Attach the TV bracket cover back onto the back of
the console after removing the TV bracket dummy
plate on the cover.
2. Run the cables through the TV bracket and mount
the bracket to the back of the console with the four
M8 BOLTS (4) and SPLIT WASHERS (5).
HARDWARE FOR STEP 4
PART TYPE DESCRIPTION QTY
4 BOLT M8x20mm 4
5 SPLIT WASHER M8 4

9
www.spirittness.com
CT900 T V BRACKET STEP FIVE
HARDWARE FOR STEP 5
PART TYPE DESCRIPTION QTY
6 SCREW M4x12mm 4
7 SPLIT WASHER M4 4
8 FLAT WASHER 4x1.0 4
9 SCREW M5x12mm 1
1. Attach the TV to the bracket with the four M4
SCREWS (6), SPLIT WASHERS (7) and FLAT
WASHERS (8).
2. Mount the plastic cover over the TV mounting
plate with the M5 SCREW (9) and attach the
cables to the TV.
3. Re-install the handrail cover and lower console
mast cover.

10
Spirit Fitness
NOTES

11
www.spirittness.com
NOTES

800.258.4555
spiritservice@spirittness.com
www.spirittness.com
Spirit Fitness
3000 Nestle Road
Jonesboro, AR 72401
CT900 TV Bracket Installation Guide
© 2018 All Rights Reserved
Revision: 02.28.2018