Spon nas-8513 User manual

IP Network Intercom Terminal Installation Instructions
1
"123456".
（2）From the right menu choose【Mandatory method configuration】, then fill in the
correct parameters in the【terminal parameters】, click "send parameters" button to
complete the IP parameters Setting.
Specification、Function unit& Parameter
Power voltage DC12V
Consumption ≤5W
Interface Network input Alarm input Alarm output Power input
Audio output
Support network protocol TCP/IP、UDP、ARP、ICMP、IGMP protocol
Network chip rating 10/100Mbps
Audio sampling 8kHz～22.050kHz, 16bit
Transmit rate 16kbps-352kbps
SNR >90dB
Frequency response 20Hz-16KHz
Malfunction Test
Fault phenomenon Reason& trouble removal
Why it appear "terminal
network services (UDP) start
fail" warning in the process of
starting server software?
Appearing this warning information, it’s usually the
local server network connection has been
disconnected, please connect the local network
cable well and exit the software, then restart it.
Why scanning tools can’t find
the terminal?
1. It`s required to close all firewalls or with data
interception function software before open the
software server
2. Network card do not compatible with terminal.
3. Using other computer to scan the machine.
Packing List
IP Network Intercom Terminal Installation Instructions
2

IP Network Intercom Terminal Installation Instructions
1
①Speaker: Restore the remote live voice.
②Status Indicator
③ Button: Press this button to call the server
designated terminal.
④ Button Indicator
⑤Pickup microphone: Pick up the live voice.
①Network input port
②Control panel interface
For debugging and temporary
terminal configuration use.
③Audio output
④Power input :Access the 12V DC
power
⑤Alarm input /alarm output port
Interface Instruction
Front Back
Appearance Installation Diagram
Note：For more details please refer to user manual.
IP Network Intercom Terminal Installation Instructions
2
Connection Diagram (Unit: mm)
Schematic Diagram of Installation
Installation Steps
①Put sealing strip on the bottom case correspondingly(Note: Sealing strip joints left a
5 mm gap);
②Connect to waterproof joint, put chock plug to hole outlet, let the power cord go
through the chock plug and the cable go through the waterproof joint, then straighten all
these lines.
③Using plastic expansion screws to fix bottom case on wall
④Using the socket head screw to fix panel on bottom case.
Note: 1、According to the real situation of the project to choose the bottom shell wiring
methods installed by upwards or downwards.
2、If it`s equipped with a rain shield, please put bottom case into the rain shield, as
picture2 shows.
IP Network Terminal Setting
（1）Using couplet cable to connect computer and terminal. In [CD: \ tools \] directory, find
and run "IP configuration tool" audio terminal, start it, enter the default password