SportsPlay 802-178 User manual

1'-0"
TYP
10'-3"
ITEM NO. PART
NUMBER DESCRIPTION QTY.
1 803-267 End Su ort 2
2 803-268 S acer Bar 2
3 803-269 Center Su ort 1
4 803-328 Ladders 2
5 116-514 5/16" x 3-1/2" Hex Bolts 4
6 116-510 5/16" x 2-1/2" Hex Bolts 12
7 326-501 5/16" Lock Washers 14
8 226-501 5/16" Lock Nuts 12
9 415-515 1-5/8" T-Clam 6 r.
10 105-015 1-5/8" Pi e Plug 14
6
DETAIL A
8
7910
1
4
9
maintenance instructions, as well as re lacement arts information.
*IMPORTANT*
*IMPORTANT**IMPORTANT*
*IMPORTANT* DETAIL B
8
7
5
2
1
Please retain this instruction sheet in your files. It contains im ortant
Sheet 1 of 2
Sheet 1 of 2Sheet 1 of 2
Sheet 1 of 2
A
AA
A
4
3
1
2
9
10
B
BB
B
SINGLE SIDE BIKE RACK 20' (PORT)
SINGLE SIDE BIKE RACK 20' (PORT)SINGLE SIDE BIKE RACK 20' (PORT)
SINGLE SIDE BIKE RACK 20' (PORT)
54321
802-178
802-178802-178
802-178

1
SINGLE SIDE BIKE RACK 20' (PORT)
SINGLE SIDE BIKE RACK 20' (PORT)SINGLE SIDE BIKE RACK 20' (PORT)
SINGLE SIDE BIKE RACK 20' (PORT)
5432
802-178
802-178802-178
802-178
Sheet 2 of 2
Sheet 2 of 2Sheet 2 of 2
Sheet 2 of 2
GENERAL ASSEMBL INSTRUCTIONS:
GENERAL ASSEMBL INSTRUCTIONS:GENERAL ASSEMBL INSTRUCTIONS:
GENERAL ASSEMBL INSTRUCTIONS:
Check all the parts and hardware with the packing list to be sure you
have received everything needed to assemble this product.
CONTACT OUR LOCAL DISTRIBUTOR OR SPORTSPLA
EQUIPMENT WITH NOTIFICATION OF AN MISSING OR
DAMAGED PARTS. Contact must be made within ten days of
receipt of your order.
Only hand tighten nuts & bolts on initial assembly. Final tightening
should be done EVENL after final assembly when unit has been
plumbed & leveled.
After assembly is complete, AN ENDS OF BOLTS PROTRUDING
BE OND NUTS SHOULD BE CUT OFF AND/OR PEENED OVER
TO REMOVED AN SHARP PROJECTIONS. Go over entire unit to
file smooth any sharp edges or projections that may have been
caused by rough handling in shipping or installation. T-Clamps are
designed for both one and two bolt connections. In many situations
one bolt is required. See specific assembly instructions.
On products with platforms install 1 - 2 degrees off level to
facilitate water drainage.
Assemble Rack as shown.1.
SPECIFIC ASSEMBL INSTRUSTIONS:
SPECIFIC ASSEMBL INSTRUSTIONS:SPECIFIC ASSEMBL INSTRUSTIONS:
SPECIFIC ASSEMBL INSTRUSTIONS:
Check MONTHL for loose bolts, damaged or broken parts.
Tighten and/or replace immediately.
GENERAL MAINTENANCE INSTRUCTIONS:
GENERAL MAINTENANCE INSTRUCTIONS:GENERAL MAINTENANCE INSTRUCTIONS:
GENERAL MAINTENANCE INSTRUCTIONS: