SportsPlay 801-178 User manual

*IMPORTANT*
*IMPORTANT**IMPORTANT*
*IMPORTANT*
Detail A
Detail C
3
4
13
10
6
5
5
6
Sheet 1 of 2
Sheet 1 of 2Sheet 1 of 2
Sheet 1 of 2
maintenance in truction, a well a replacement part information
Plea e retain thi in truction heet in your file . It contain important
ITEM NO. PART
NUMBER DESCRIPTION QTY.
1 803-267 End Support 2
2 803-268 Spacer Bar 2
3 803-269 Center Suuport 1
4 803-328 Ladder 2
5 105-015 1-5/8” Pipe Plug 14
6 415-515 1-5/8” “T” Clamp 6pr
7 196-644 3/8” x 8” Anchor Bolt 8
8 116-514 5/16” x 3-1/2” Hex Bolt 4
9 116-510 5/16” x 2-1/2” Hex Bolt 12
10 326-501 5/16” Lock Wa her 12
11 216-601 3/8” Hex Nut 8
12 226-601 3/8” Lock Nut 8
13 226-501 5/16” Lock Nut 16
Detail B
7
Detail D
1
?
12
11
Concrete
5
4
?
6
5
13
10
1
13
6
10
6
9
6
321
SINGLE SIDE BICYCLE RACK
SINGLE SIDE BICYCLE RACKSINGLE SIDE BICYCLE RACK
SINGLE SIDE BICYCLE RACK
54
801-178
801-178801-178
801-178
21’-6”
10’-3”
10’-3”
1’-0”
8
12
10
2
1
5

SINGLE SIDE BICYCLE RACK
SINGLE SIDE BICYCLE RACKSINGLE SIDE BICYCLE RACK
SINGLE SIDE BICYCLE RACK
54321
801-178
801-178801-178
801-178
GENERAL ASSEMBLY INSTRUCTIONS:
GENERAL ASSEMBLY INSTRUCTIONS:GENERAL ASSEMBLY INSTRUCTIONS:
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the arts and hardware with the acking list to be sure you
have received everything needed to assemble this roduct.
CONTACT YOU LOCAL DISTRIBUTOR WITH NOTIFICATION OF
ANY MISSING OR DAMAGED PARTS. Contact must be within
ten days of recei t of your order.
Only hand tighten nuts & bolts on initial assembly. Final tightening
should be done EVENLY after final assembly when unit has been
lumbed and leveled.
After assembly is com lete, ANY ENDS OF BOLTS PROTRUDING
BEYOND NUTS SHOULD BE CUT OFF/OR PEENED OVER TO
REMOVE ANY SHARP PROJECTIONS. Go over entire unit to file
smooth any shar edges or rojections that may have been caused
by rough handling in shi ing installation. T-Clam s are designed for
both one and two bolt connections. In many situations only one bolt
is required. See s ecific assembly instructions.
On roducts with latforms install 1 - 2 degrees off level to facilitate
water drainage.
Sheet 2 of 2
Sheet 2 of 2Sheet 2 of 2
Sheet 2 of 2
GENERAL MAINTENANCE INSTRUCTIONS:
GENERAL MAINTENANCE INSTRUCTIONS:GENERAL MAINTENANCE INSTRUCTIONS:
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken arts. Tighten
and/or re lace immediately.
SPECIFIC ASSEMLY INSTRUCTIONS:
SPECIFIC ASSEMLY INSTRUCTIONS:SPECIFIC ASSEMLY INSTRUCTIONS:
SPECIFIC ASSEMLY INSTRUCTIONS:
Com letely assemble Bike Rack.1.
Position Bike Rack in ro er osition, mark footing holes,2.
move Bike Rack to one side, and dig holes.
Assemble Anchor Bolts to end su orts and lace Bike Rack3.
in osition over footing holes.
Pour concrete. Wait 48 hrs. before using equi ment.4.