SQ Professional SferA User manual

BEFORE OPERATING THIS UNIT, PLEASE CAREFULLY READ THE FOLLOWING INSTRUCTIONS.
SQIM 8122-8123-8124 01-03-19 V4
instruction manual
SferA
MARBLE KETTLE

HOT SURFACE!
SQIM 8122-8123-8124 01-03-19 V4 | SQ Professional Ltd © 2019 All rights reserved
Sfera Marble Kettle Instruction Manual
FEATURES
FEATURES
1 Spout with filter
2 Handle
3 Lid with knob
4 Stainless steel cordless kettle body
5 Water level indicator
6 Concealed heating element
7 ON/OFF switch with indicator light.
8 Base unit with 360˚connector
IMPORTANT!
Due to hot parts and potential hazards the appliance is not
suitable for the use of children under 8 years old. Even when
off please keep the appliance and cord out of the reach of
children. Children over 8 must be supervised by an adult at all
times when using or cleaning the appliance. This is not a toy!
The appliance can be used by persons with reduced physical,
sensory or mental capabilities if they have been given
supervision and instruction and understand the use and
hazards involved.
Always disconnecttheappliancefromthemains supplysocket
if it is left unattended and before assembling, disassembling
or cleaning.
If the mains cable is damaged, it must be replaced by qualified
persons in order to avoid any hazards.
360°
SPECIFICATIONS
Rated Voltage: . . . . . . . . . . . . . 220-240V
Frequency: . . . . . . . . . . . . . . . . . . . 50Hz
Rated Power: . . . . . . . . . . . . . . . 1850-2200W
Rated Capacity: . . . . . . . . . . . . 1.8L
READ THE INSTRUCTIONS AND KEEP THEM SAFE. REMOVE ALL PACKAGING BEFORE USE.

All images are for illustration purposes only. Actual products may vary.
IMPORTANT SAFEGUARDS
Sfera Marble Kettle Instruction Manual
IMPORTANT SAFEGUARDS
WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE
FOLLOWING:
1 Read all instructions carefully before using the appliance.
2 This appliance is intended for household use only.
It is not suitable for commercial use such as staff
kitchen areas and other working environments.
3 Ensure that the appliance is always placed on a firm and flat
surface, away from the edge of the work top. Do not place the
appliance onto a metal tray or metal surface whilst in use.
Do not place the appliance on, or near, a hot gas or electric
burner or in a heated oven. Do not operate the appliance with
wet hands or barefoot.
4 Keep the appliance and mains cable away from the edges of
work tops and out of reach of children. Route the cable so
it does not overhang, and cannot be tripped over or caught.
5 Do not let the cable run across an open space, such as
between a low socket and a table, or across any hot area, such
as cooker. Heat may damage the mains cable.
6 The connections on both sides of the mains cable (the
appliance and socket) should never be strained. If the mains
cable is damaged it must be replaced by qualified person or
service to avoid any hazards.
7 Do not use the appliance in a bathroom, near
water, or outdoors. Do not immerse any of the
parts (appliance, mains cable, plug) in water or
other liquids to protect against fire, electric shock
and personal injury.
8 Do not use the appliance if it is damaged or
malfunctions. Do not leave the appliance unattended
whilst in use. Use and store it out of reach of children.
9 This appliance must not be operated by an external timer or a
remote control system.
10 SQ Professional Ltd may not be held liable for eventual
damages to persons, animals or objects caused by incorrect
installation or deriving from improper, erroneous or
unreasonable use.
11 The top of the base unit should always be kept dry,
especially around connection area. Before drying disconnect
the power supply; ensure that the base unit is completely
dry before you reconnect the appliance to power supply.
12 Pour water out of the kettle slowly and carefully, do not
overtilt or tip the kettle too fast to prevent spillage and
splashing. Remove the kettle from the base unit before
filling or pouring.
13 Do not move the kettle when it is switched on. Use extreme
caution when moving a kettle containing hot water.
14 Do not switch the kettle on unless it contains at least two cups
of water. Avoid filling it up above the MAX mark to prevent the
hot water spewing out. Remove the kettle from the base unit
before you fill it with water.
15 Always close the lid and have the filter in place before
you switch the kettle on. Do not open the lid whilst the
water is boiling. Avoid contact with steam while the water is
boiling and after the kettle is switched off.
16 Use the handle and knobs on the appliance and avoid
touching any hot surfaces.
17 The switch should never be held fixed in the ON position
as this may cause damage to the switch-off mechanism.
18 Do not remove the kettle off from the base unit without
switching it off first. Unplug the stand when not in use.
19 Unplug the kettle from the socket before cleaning or removing
any parts. Ensure that the kettle is completely cooled down
before cleaning and storing away. Keep the kettle, base unit,
cable, and plug away from sources of heat. Store in a dry place.
20 Do not use the kettle for any purpose other than
heating water.
21 Use the kettle only with the base unit supplied (and vice
versa) and do not tamper with the connector in any way.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
SCALDING
A SCALD HAZARD CAN LAST FOR LONG TIME AFTER BOILING. TAKE
CARE WHEN OPENING THE LID AS STEAM WILL ESCAPE FROM THE
OPENING. IF THIS DOES HAPPEN RUN COLD WATER OVER THE
AFFECTED AREA IMMEDIATELY. DO NOT STOP TO REMOVE CLOTHING
AND GET MEDICAL HELP QUICKLY.
BEFORE FIRST USE
Fill to the MAX mark, boil, discard the water, then rinse. Do this
3 times, to remove manufacturing dust, etc. Ensure that electrical
connections are completely dry before using the appliance.
SAFE HANDLING
1 Pour water from the kettle slowly, this to prevent splashing
and scalding with the hot water.
2 Fill the water through the spout whenever possible, to help
free the filter from limescale build-up. There should always
be minimum amount of water in the kettle before you switch it
on (MIN mark on the water level indicator ). Boil only the
necessary amount of water at the time as this can save electricity.

SQIM 8122-8123-8124 01-03-19 V4 | SQ Professional Ltd © 2019 All rights reserved
Sfera Marble Kettle Instruction Manual
USE & CARE
SWITCHING ON
1 Place the kettle on the base unit . Make sure that the kettle
is locked on to the 360˚ connector, which allows the kettle to
be put in any position (ideal for left and right handed users).
2 Plug the stand into a power socket (switch the socket on, if it
is applicable).
3 Switch the kettle ON. The water level indicator will light up
and the kettle will start heating up the water.
SWITCHING OFF
1 Once the water is boiled the kettle will automatically
switch off.
2 Lift the kettle from the base unit and hold it level to avoid
splashing the hot water. To boil the water again, place it back
on the base unit and switch to ON again (wait for a minute
after the kettle has switched off before switching it on again).
3 If there is not enough water in the kettle or if it is empty, it
will switch the power off automatically. To switch it back on,
refill the kettle and wait a few minutes for it to cool down.
Then use as normal. Using insufficient water will shorten the
life of the appliance.
CARE & MAINTENANCE
BEFORE CLEANING ALWAYS CHECKTHAT THE KETTLE IS SWITCHED OFF
AND HAS COMPLETELY COOLED DOWN.
1 Unplug the base unit (switch the socket off first, if
applicable) and let the kettle cool completely.
2 Wipe the kettle, inside and out, with a damp cloth. Do not
use abrasive cleaners on the outside of the appliance to avoid
scratching the surface.
3 Ensure that all connectors and sockets are completely dry.
DESCALE - EVEN IN SOFT WATER AREAS
1 This appliance is fitted with concealed heating element
and must be descaled regularly. The frequency of descaling
depends on usage and water hardness. Excessive scale
causes overheating, reduces the kettle’s life, and may trigger
the boil-dry cut-out, as well as damage to the element which
invalidates the warranty.
2 Use appropriate descaling product suitable for stainless steel,
glass or plastic and follow the provided instructions carefully.
3 Products returned under warranty with faults due
to scale will be subject to a repair charge.
WIRING
This appliance must be earthed.
Should the power cable or the
power plug become damaged,
arrange for these to be replaced
by Customer Service or qualified
person before continuing to use
the appliance. This appliance is
fitted with a 13A BS1362 fuse in
a 13A BS 1363 plug.
Do not use a non-wireable plug unless the fuse cover
is in place.
ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due
to hazardous substances in electrical and electronic
goods, appliances marked with this symbol must not
be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
SERVICE
The product is not user-serviceable. If it is not working, read the
instructions, check the plug fuse and main fuse/circuit breaker.
If it is still not working, consult your retailer. If that does not solve
the problem ring Customer Service – they may be able to offer
technical advice. Please have the Model Number to hand, as
they will not be able to help you without it. If you are advised to
return the product to us, pack it carefully, include a note with your
name, address, day phone number, and description of the problem.
If under a warranty, say where and when it was purchased and
include a valid VAT receipt. Send it to SQ Professional Ltd.
WARRANTY
THE WARRANTY FOR THIS PRODUCT IS COVERED BY SQ PROFESSIONAL
LIMITED. ANY FAULTS WITH THIS PRODUCT ARISING THROUGH A
MANUFACTURER DEFECT WILL BE COVERED FOR 1 YEAR FROM THE DATE
OF PURCHASE, SUBJECT TO A VALID VAT RECEIPT BEING PRESENTED. THIS
DOES NOT INCLUDE FAULTS OR DAMAGE CAUSED BY MISUSE OF GENERAL
WEAR AND TEAR.
PLEASE CONTACT CUSTOMER SERVICES ON 01992 716 070 OR SEND AN
E-MAIL TO [email protected]OM, MONDAY TO FRIDAY FROM
09:30 - 17:30. THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Voltage Business Centre, Units 1 - 3
6 Mollison Avenue, Enfield, EN3 7XQ
T: 01992 716 070 | F: 01992 700 538 |[email protected]
WWW.SQPROFESSIONAL.COM