SQ Professional gems User manual

BEFORE OPERATING THIS UNIT, PLEASE CAREFULLY READ THE FOLLOWING INSTRUCTIONS.
SQIM 3426-3427-3428-3429-3430-3431-3432-5684-7208 14-10-2020 V11
instruction manual
gems
LEGACY KETTLE

360°
HOT SURFACE!
SQIM 3426-3427-3428-3429-3430-3431-3432-5684-7208 14-10-2020 V11 | SQ Professional Ltd © 2020 All rights reserved
Gems Legacy Kettle Instruction ManualFEATURES
2
FEATURES
1 Spout with filter
2 Handle
3 Lid with knob
4 Stainless steel cordless kettle body
5 Water level indicator
6 Concealed heating element
7 ON/OFF switch with indicator light.
8 Base unit with 360˚connector
READ THE INSTRUCTIONS AND KEEP THEM SAFE. REMOVE ALL PACKAGING BEFORE USE.
SPECIFICATIONS
Rated Voltage: ....................... AC220-240V
Frequency: ................................. 50Hz
Rated Power: .......................... 1850-2200W
Rated Capacity: .................... 1.8L
IMPORTANT!
Due to hot parts and potential hazards, this appliance is not suitable for the use
of children under 16 years old.
When off please keep the appliance and mains cable out of the reach of children.
Children under the age of 16 must be supervised by an adult at all times when
using or cleaning the appliance. This is not a toy!
The appliance can be used by persons with reduced physical, sensory or mental
capabilities if they have been given supervision and instruction and understand
the use and hazards involved.
Always disconnect the appliance from the mains supply socket if it is left
unattended and before assembling, disassembling or cleaning.
If the mains cable is damaged, it must be replaced by qualified persons in
order to avoid any hazards.

All images are for illustration purposes only. Actual products may vary.
IMPORTANT SAFEGUARDSGems Legacy Kettle Instruction Manual
3
IMPORTANT SAFEGUARDS
WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE
FOLLOWING:
1 Read all instructions carefully before using the appliance.
2 This appliance is intended for household use only.
It is not suitable for commercial use such as staff
kitchen areas and other working environments.
3 Ensure that the appliance is always placed on a firm and flat
surface, away from the edge of the worktop. Do not place the
appliance onto a metal tray or metal surface whilst in use.
Do not place the appliance on, or near, a hot gas or electric
burner or in a heated oven. Do not operate the appliance with
wet hands or barefoot.
4 Keep the appliance and mains cable away from the edges of
worktops and out of reach of children. Route the cable so it
does not overhang, and cannot be tripped over or caught.
5 Do not let the mains cable run across an open space, such
as between a low power socket and a table, or across any
hot area, such as cooker. Heat may damage the mains cable.
6 The connections on both sides of the mains cable (the
appliance and a power socket) should never be strained. If
the mains cable is damaged it must be replaced by a qualified
person or service to avoid any hazards.
7 Do not use the appliance in a bathroom, near
water, or outdoors. Do not immerse any of the
parts (appliance, mains cable, plug) in water or
other liquids to protect against fire, electric shock
and personal injury.
8 Do not use the appliance if it is damaged or
malfunctioning. Do not leave the appliance
unattended whilst in use. Use and store it out of
reach of children.
9 This appliance must not be operated by an external timer or a
remote control system.
10 SQ Professional Ltd will not be held liable for eventual
damages to persons, animals or objects caused by incorrect
installation or deriving from improper, erroneous or
unreasonable use.
11 The top of the base unit
8
should always be kept dry,
especially around the connection area.
12 Before drying, disconnect the power supply; ensure that
the base unit
8
is completely dry before you reconnect the
appliance to power supply.
13 Pour the water out of the kettle slowly and carefully, do
not over tilt or tip the kettle too fast to prevent spillage and
splashing. Remove the kettle from the base unit
8
before
filling or pouring.
14 Do not move the kettle when it is switched on. Use extreme
caution when moving a kettle containing hot water.
15 Do not switch the kettle on unless it contains at least two cups
of water.
16 Avoid filling it up above the MAX mark to prevent the hot water
spewing out.
17 Always remove the kettle from the base unit
8
before you fill it
with water.
18 Always close the lid
3
and have the filter
1
in place before
you switch the kettle on. Do not open the lid
3
while the
water is boiling.
19 Avoid contact with steam while the water is boiling and after
the kettle is switched off.
20 Use the handle
2
and knobs
3
on the appliance and avoid
touching any hot surfaces.
21 The switch
7
should never be held fixed in the ON position
as this may cause damage to the switch-off mechanism.
22 Do not remove the kettle from the base unit
8
without
switching it off first. Unplug the base unit
8
when not in use.
23 Unplug the kettle from the power socket before cleaning
or removing any parts. Ensure that the kettle is completely
cooled down before cleaning and storing away. Keep the
kettle, base unit
8
, mains cable, and plug away from sources
of heat. Store in a dry place.
24 Do not use the kettle for any purpose other than
heating water.
25 Use the kettle only with the base unit
8
supplied (and vice
versa) and do not tamper with the connector in any way.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE!
SCALDING
A SCALD HAZARD CAN LAST FOR A LONG TIME AFTER BOILING.
TAKE CARE WHEN OPENING THE LID AS STEAM WILL ESCAPE FROM
THE OPENING. IF THIS DOES HAPPEN, RUN COLD WATER OVER
THE AFFECTED AREA IMMEDIATELY. DO NOT STOP TO REMOVE
CLOTHING AND GET MEDICAL HELP QUICKLY.
BEFORE FIRST USE
Fill to the MAX mark, boil, discard the water, then rinse. Do
this three times, to remove manufacturing dust. Ensure that
the electrical connections are completely dry before using the
appliance.
SAFE HANDLING
1 Pour water from the kettle slowly to prevent splashing and
scalding with the hot water.
2 Fill the water from the top to help free the filter from limescale
build-up. There should always be a minimum amount of water in
the kettle before you switch it on (MIN mark on the water level
indicator ). Only boil the necessary amount of water at one
time, as this can save time and electricity.

10 AMP
SQIM 3426-3427-3428-3429-3430-3431-3432-5684-7208 14-10-2020 V11 | SQ Professional Ltd © 2020 All rights reserved
Gems Legacy Kettle Instruction ManualUSE & CARE
4
SWITCHING ON
1 Place the kettle on the base unit
8
. Make sure that the kettle
is locked on to the 360˚connector, which allows the kettle to
be put in any position (ideal for left and right-handed users).
2 Plug the mains cable of the base unit
8
into a power socket
(switch the socket on, if it is applicable).
3 Switch the kettle ON. The ON/OFF switch
5
will light up and
the kettle will start heating up the water.
SWITCHING OFF
1 Once the water is boiled the kettle will automatically
switch off.
2 Lift the kettle from the base unit
8
and hold it level to avoid
splashing the hot water.
3 To boil the water again, place the kettle back on the base unit
8
and switch it on again (after the kettle has switched off wait
for a minute before switching it on again).
4 If there is not enough water in the kettle or if it is empty, it
will switch the power off automatically. To switch it back on,
refill the kettle and wait a few minutes for it to cool down,
then use as normal. Using insufficient water will
shorten the life of the appliance.
CARE & MAINTENANCE
BEFORE CLEANING ALWAYS CHECK THAT THE KETTLE IS SWITCHED OFF
AND HAS COMPLETELY COOLED DOWN.
1 Unplug the base unit (switch the power socket off first, if
applicable) and let the kettle cool completely.
2 Wipe the kettle, inside and out, with a damp cloth. Do not
use abrasive cleaners on the outside of the appliance to avoid
scratching the surface.
3 Ensure that all connectors and sockets are completely dry.
DESCALE - EVEN IN SOFT WATER AREAS
1 This appliance is fitted with a concealed heating element
6
and therefore must be descaled regularly. The frequency of
descaling depends on usage and water hardness. Excessive
scale causes overheating, reduces the life of the appliance,
and may trigger the boil-dry cut-out feature. This may
damage the concealed heating element
6
and invalidate
the guarantee.
2 Use an appropriate descaling product suitable for stainless steel,
glass or plastic and follow the provided instructions carefully.
3 Products returned under guarantee with faults
due to scale will be subject to a repair charge.
WIRING
DO NOT USE A NON-WIREABLE PLUG UNLESS
THE FUSE COVER IS IN PLACE.
Should the power cable or the power
plug become damaged, arrange for
these to be replaced by Customer
Service or qualified person before
continuing to use the appliance. This
appliance is fitted with a 10A BS1362
fuse in a 10A BS 1363 plug.
ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due
to hazardous substances in electrical and electronic
goods, appliances marked with this symbol must not
be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
SERVICE
The product is not user-serviceable. If it is not working, read the
instructions, check the plug fuse and main fuse/circuit breaker.
If it is still not working, consult your retailer. If that does not solve
the problem, ring Customer Service – they may be able to offer
technical advice. Please have the Model Number to hand, as they
will not be able to help you without it. If you are advised to return
the product to us, pack it carefully, include a note with your name,
address, day phone number, and description of the problem.
If under a guarantee, say where and when it was purchased and
include a valid VAT receipt. Send it to SQ Professional Ltd.
GUARANTEE
THE GUARANTEE FOR THIS PRODUCT IS COVERED BY SQ PROFESSIONAL
LIMITED. ANY FAULTS WITH THIS PRODUCT ARISING THROUGH A
MANUFACTURER DEFECT WILL BE COVERED FOR 1 YEAR FROM THE DATE
OF PURCHASE, SUBJECT TO A VALID VAT RECEIPT BEING PRESENTED. THIS
DOES NOT INCLUDE FAULTS OR DAMAGE CAUSED BY MISUSE OF GENERAL
WEAR AND TEAR.
PLEASE CONTACT CUSTOMER SERVICES ON 01992 716 070 OR SEND AN
E-MAIL TO [email protected]OM, MONDAY TO FRIDAY FROM
09:30 - 17:30. THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Voltage Business Centre, Units 1 - 3
6 Mollison Avenue, Enfield, EN3 7XQ
T: 01992 716 070 | F: 01992 700 538 |[email protected]
WWW.SQPROFESSIONAL.COM