Table of contents Operating Instructions KB2 Keyboards
R. STAHL HMI Systems GmbH / OI_Keyboard_KB2_en_V_01_00_02.docx / 07.03.2022 Page 3 of 68
4.2 Dimensions 22
4.2.1 Keyboard with pointing device 22
4.2.2 Keyboard with pointing device inside HSG 23
4.2.3 Keyboard with pointing device and UB03 inside HSG 23
4.2.4 Keyboard with pointing device inside HSG, support arms for
FR / CFR / BD 24
4.2.5 Keyboard with pointing device and UB03 inside HSG, for
FR / CFR / BD 24
4.2.6 Keyboard with pointing device inside HSG, support arms for
Yokemount 25
4.2.7 Keyboard with pointing device inside HSG for SHARK
wall mounting 25
4.3 Operating elements 26
4.4 Markings on the device 27
4.4.1 Position 27
4.4.2 Design of a type label 27
4.4.3 Type code layout 28
4.4.4 Type key code KB2 device versions 29
4.4.5 Type key code KB2-HSG assemblies 29
4.4.6 Ex classification ATEX / IECEx 30
4.4.7 Ex classification EAC 31
5Transport and storage 32
6Unpacking 32
7Mounting and installation 33
7.1 Note on mounting and installation 33
7.2 Requirements for site of installation 33
7.3 Mounting types 33
7.4 Installation 34
7.4.1 General information on electric connection 34
7.4.2 Connecting the device 34
7.4.3 Grounding the device 34
8Initial start-up 35
9(Re-) Commissioning 35
10 Operation 36
10.1 Switching the device on and off 36
11 Maintenance, overhaul and repair 37
11.1 Servicing 37
11.2 Maintenance 38
11.3 Repair 38
12 Returning the device 39
13 Cleaning 39
14 Disposal 40
15 Accessories 40
16 Appendix A 41
16.1 Technical data 41
17 Appendix B 43
17.1 Permitted maximum values 43
