Stanley Healthcare WanderGuard BLUE Standard User manual

WanderGuard® BLUE Standard Bracelet User Guide
Part Numbers: WGB-TAG-1000-90D, WGB-TAG-1000-1Y, WGB-TAG-1000-3Y
STANLEY Healthcare 75 Portsmouth Blvd., Suite 220, Portsmouth, NH 03801 Tel: [phone] Web: www.stanleyhealthcare.com ©2021 STANLEY Healthcare. All Rights Reserved. 2021/08/03. 0980-470-000 Rev H. KB# 10157
FCC Part 15, sub-part C class B, sub-part B, EN 300-328, EN 300-330, EN 301-489, RSS210 (Canada), Radio Equipment Directive 2014/53/EU (RED), Radio Equipment Directive S.I.2017/1206 (RED), RoHS 2 Directive 2011/65/EU, RoHS 2 Directive S.I.2012/3032. Safety: CE, UKCA, EN62368/UL62368/IEC62368/UL294
Bracelet Specifications
LF Frequency 125 kHz
BLE Frequency 2400-2483.5 MHz
Battery Power 3 VDC
Battery Life WGB-TAG-1000-90D: 90 Days
WGB-TAG-1000-1Y: 1 Year
WGB-TAG-1000-3Y: 3 Years
Operating
Temperature
32° to 122°F (0° to +50°C)
Humidity 0-95% RH @ 70°F (21°C), non-
condensing
IP Rating IP67
UL294 ACC Accessory, TYPE: S, 17XS
Dimensions 1.08 x 1.16 x 0.6”
(2.74 x 2.95 x 1.5 cm)
Weight 0.41 oz. (11.6 g)
The Bracelet is intended for indoor use only.
STANLEY Healthcare reserves the right to change
specifications without notice.
Warranty
STANLEY Healthcare’s WanderGuard BLUE
Bracelets are warranted against defects in
materials and workmanship and shall perform
in accordance with published specifications for
the following periods:
• WGB-TAG-1000-90D: 90 Days
• WGB-TAG-1000-1Y: 1 Year
• WGB-TAG-1000-3Y: 3 Years
The STANLEY Healthcare Bracelet warranty
is binding only if the Bracelet was activated
before the “Activate By” date printed on the
Bracelet back label. The warranty starts when
the Bracelet is activated.
Statements
United States—Federal Communication
Commission (FCC)
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide rea-
sonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this
equipment in a residential area is likely to cause
harmful interference in which case the user will
be required to correct the interference at his
own expense.
Warning: Changes or modifications not expressly
approved by STANLEY Healthcare could void the
user’s authority to operate the equipment.
Canada—Industry Canada
The term “IC:” before the certification/registration
number only signifies that Industry Canada
technical specifications were met.
Limitation of Liability
This Product has been designed for use to reduce
the risk of resident wandering through remote
detection.
The range, accuracy, function and performance
of this Product may vary from the published
specifications due to many factors, including,
without limitation, site impairments from structural
eects, metal objects in the vicinity, placement of
the receiver and transmitter, interference from
other electrical devices, atmospheric eects,
installation, and maintenance. There may be
other factors, which also aect performance of
this Product.
STANLEY Healthcare does not guarantee that this
Product will detect 100% of resident wanderings.
STANLEY Healthcare does not guarantee that this
Product will not return false reports of resident
wandering.
Weekly testing and maintenance of this Product,
as described in the Product documentation,
is essential to verify the system is operating
correctly and to ensure that the probability of
detecting an alarm and/or locating the transmitter
are maximized.
The failure to undertake regular testing and
maintenance will increase the risk of system
failure and failure to detect resident wandering.
The failure to undertake regular testing and
maintenance will increase the risk of false reports
of resident wandering.
STANLEY Healthcare hereby disclaims all
warranties, express or implied, arising out of or
in connection with any of its Products or the use
or performance thereof, including but not limited
to, where allowable by law, all other implied
warranties or conditions of merchantable quality
and fitness for a particular purpose and those
arising by statute or otherwise in law or from a
course of dealing or usage of trade.
STANLEY Healthcare’s liability to you or anyone
claiming through or on behalf of you with
respect to any claim or loss arising out of the
use or misuse of STANLEY Healthcare’s Product,
defective products or materials, improper instal-
lation or maintenance of STANLEY Healthcare’s
Product or products or the system in which they
are incorporated, or alleged to have resulted
from an act or omission of STANLEY Healthcare
or any person, negligent or otherwise, shall be
limited to:
A) the repair or replacement of defective Product
or materials supplied by STANLEY Healthcare
during the warranty period as set out in the
Product documentation; or, at the option of
STANLEY Healthcare,
B) a refund of the purchase price of the Product
supplied by STANLEY Healthcare.
In no event shall STANLEY Healthcare be liable
for general, specific, indirect, consequential,
incidental, exemplary or punitive damages or any
losses or expenses suered by you or anyone
else, whether or not STANLEY Healthcare, or
its employees, officers, agents, resellers or
installers, has been informed of the risk of such
loss or expense and whether or not such losses
or expenses were foreseeable.

Introduction
The WanderGuard BLUE Standard Bracelet
(referred to as the Bracelet) signals the
WanderGuard BLUE EX5700 Controller
when it is in field. The Controller issues an
alarm and can lock a monitored door so
that an at-risk resident wearing the bracelet
cannot leave through the door. The resident
typically wears the WanderGuard BLUE
Bracelet on the wrist like a watch. The
bracelet can also be worn on the ankle.
There are three types of bracelets: 3-Year
Bracelet (WGB-TAG-1000-3Y) which has a 3
year battery life and 90-Day Bracelet (WGB-
TAG-1000-90D) which has a 90 day battery
life. The 1-Year Bracelet (WGB-TAG-1000-1Y)
has a 1 year battery life, and transmits mes-
sages every 20 seconds when not in the
EX5700 Controller’s range.
The type is indicated on the back label.
The M/N (Model Number) is WGB-TAG-1000-
xxx, where xxx is either 3Y, 1Y, or 90D.
Bracelet Activation
The bracelet must be activated before apply-
ing it to a resident’s wrist or ankle. Once acti-
vated, a bracelet cannot be deactivated. The
bracelet is activated using the WanderGuard
BLUE Detector. For more information about
the activation process and the WanderGuard
BLUE Detector, please refer to the Wander-
Guard BLUE Deployment Guide.
Cleaning the Bracelet
Follow these recommendations for cleaning
the bracelet. WanderGuard BLUE straps are
single-use and cannot be re-attached.
• Use a mild soap and water to remove
any apparent debris.
• Disinfect bracelets by wiping with an
alcohol sanitizer or germicidal cleaner
for 60 seconds. Use only cleaners
marked as safe for plastics. Bracelets
are incompatible with disinfectants
containing Glycol Ether.
• Dry with a soft, clean cloth.
• Do not clean in an autoclave.
Bracelet Bands
There are two types of bands that can be
used with the WanderGuard BLUE Bracelet:
Simple wristband and Securaband.
The Simple wristband arrives with a single
bracelet shipment. The band has one size.
The Securaband strap provides a robust
physical barrier to unauthorized removal.
Simple Wristband
The simple wristband includes a vinyl strap
with a metal snap and comes in a package
of 10 bands (801A2701).
To apply the bracelet to a resident:
1 Slide a WanderGuard BLUE Bracelet onto
the strap.
2 Wrap the band around the resident’s
wrist or ankle.
3 Place a band hole on the metal pin leav-
ing a little space between the band and
the wrist or ankle.
4 Lock the back using the metal snap.
To remove the bracelet, cut the band with
safety scissors.
Securaband
Securaband Starter Kit
The Seuraband Starter Kit (WGB-SECUR-
STARTER) includes:
• WanderGuard BLUE Bracelet (WGB-
TAG-1000-90D or WGB-TAG-1000-3Y)
• WanderGuard BLUE sizing tool
(804A1501)
• WanderGuard BLUE straps
• WanderGuard BLUE removal tool
(WGB-SECUR-REMOV)
Applying the Bracelet
Apply the bracelet as follows:
1 To determine the strap size, wrap the
sizing tool around the resident’s wrist or
ankle, making sure that the STANLEY
Healthcare logo is facing you. The strap
size is the first number to the right of the
measuring bar (in this example, size 14).
2
NOTE: Measure carefully to ensure
that the appropriate strap size is
selected. Once the strap has been
attached, it cannot be used again.
Select the appropriate WanderGuard
BLUE strap from storage (the size is
printed on the box as well as on the inside
of the strap).
3 Slide a WanderGuard BLUE Bracelet
onto the strap, making sure that both the
bracelet’s back label with serial number
and the size stamp on the strap are
facing you.
4 Position the strap around the resident’s
wrist or ankle and insert the free end of
the strap into the clasp until it clicks
into place.
5 Discard the sizing tool (it may be recycled,
but not used again).
Removing the Bracelet
Remove the bracelet as follows:
1 Place the removal tool over the clasp,
making sure that the chevron on the
clasp and the lanyard ring on the tool are
facing in the same direction.
2 Squeeze the tool handles together to
unlock the clasp.
3 While holding the tool handles together,
pull the strap end out of the clasp.
4 Slide the bracelet o the strap, clean and
store the bracelet, and discard the strap.
Measuring Bar
Removal
Tool
Strap w/Clasp
Sizing
Tool
Instructions for the WanderGuard BLUE Standard Bracelet
Bracelet