Stark 65116 Original instruction manual

14 GALLON GAS CADDY
SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY,
OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE
PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM
(OR MONTH AND YEAR OF PURCHASE IF PRODUCT HAS NO NUMBER).
OWNER’S MANUAL AND SAFETY INSTRUCTIONS
ITEM: 65116
FOR QUESTIONS PLEASE CALL OUR CUSTOMER SUPPORT: [phone] MON-FRI 9AM TO 3PM PST

GENERAL SAFETY WARNINGS
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator. Read
carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to
follow the safety rules and other basic safety precautions may result in serious personal injury.
1
Keep away from ame, pilot lights, stoves, heaters, electric motors and other sources of ignition.
IMPORTANT SAFETY INFORMATION
KEEP OUT OF REACH OF CHILDREN.
DO NOT store in vehicle or living space.
Store in well ventilated area, away from direct sunlight.
USE OUTDOORS ONLY.
DO NOT SMOKE when using container.
Keep container closed when not in use. VAPORS HARMFUL to lungs if inhaled.
Avoid prolonged breathing of vapors. POISON. HARMFUL OR FATAL IF SWALLOWED.
If swallowed: do not induce vomiting. Call physician immediately.
DO NOT siphon by mouth.
Not suitable for racing fuel.
DO NOT overll container.
ALWAYS place container on ground when lling.
DO NOT Fill in the back of a pickup truck or inside any vehicle.
TIE DOWN CONTAINER HORIZONTALLY DURING TRANSPORTATION. FULL CONTAINER IS VERY
HEAVY. REMOVAL FROM VEHICLE REQUIRES MORE THAN ONE PERSON.
GASOLINE - DANGER EXTREMELY FLAMMABLE VAPORS CAN EXPLODE when ignited by a spark
or ame source many feet away. VAPORS CAN CAUSE A FLASH FIRE!

2
PRODUCT INFORMATION
• Size:16 x 13 x 34 in
• Molded from durable, high-density polyethylene
• 10’ hose with hanger for easy storage
• Wheeled for easy transportation, high density polypropelyne for dent, corrosion
and rust resistance
• Siphon based pump System. Hand pump allows you to eliminate spillage and
overlls by stopping and restarting the ow of fuel when needed
• Adds Extra shine to your product. Hand pump allows you to eliminate spillage
and overlls by stopping and restarting the ow of fuel when needed.

3
OPERATION
1. Connect hose assembly (as per Fig. 2).
2. Open both tank shut-off valve and hose shut-
off valve.
3. Open vent screw on ll cap.
4. This Gas Caddy operates in a gravity feed
mode, therefore Your gas caddy MUST BE
HIGHER than tank to be lled. Squeeze pump
handle repeatedly to start the ow of fuel. Hold
the pump handle to continue lling. Let go of
pump handle to stop ow of fuel.
5. Close vent screw and both shut-off valves.
6. Hang hose on hanger.
FILLING INSTRUCTIONS
1. Lay tank in horizontal position.
2. Ensure tank shut-off valve is closed. Remove ll cap.
3. Pump fuel. - DO NOT OVERFILL
4. Replace ll cap, ensure manual vent screw on cap is closed.
5. Containers should never be lled in or on the back of a pickup truck, marine craft, or any other
vehicle
6. Fill the container slowly to decrease the chance of static electricity buildup and to minimize spilling
or splattering.
7. NEVER smoke, use lighters, light matches, use cell phones or other electrical devices while lling.
LIFTING INSTRUCTIONS
1. IMPORTANT-TANK IS HEAVY, DO NOT attempt to lift alone.
2. Lay tank in horizontal position.
3. Use top pull handle and hand holds on base to lift. ONE PERSON AT EACH END.
LIFTING INSTRUCTIONS
1. Lay tank in horizontal position and close both shut-off valves.
2. Disconnect hose assembly and remove ll cap and Insert nozzle into ll neck.
3. Keep valve above nozzle. Open hose shut-off valve.
4. Squeeze pump handle repeatedly until hose is empty. Close hose shut-off valve.
5. Replace ll cap.
OF NOTE
PRODUCT MADE IN CHINA

4
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY
OF NOTE
PRODUCT MADE IN CHINA