Start cyli-SIZE LAB01 User manual

LAB01
Manual Label Applicator
Dispenser
Core Holder (2)
Load Label Roll
Reel Guide (2)
ITEMS INCLUDED
1
1
2
HandleHex Wrench Thumbscrew (2)
A: Install handle onto feed roller
B. Install and tighten the thumb screws
A: Place bottle onto rollers and adjust screws
with hex wrench to position rollers until
bottle rests 1 - 2mm above strip plate
B: Tighten screws on both sides and remove
your bottle
3
4
Position Labels
BA
C
A: Slide reel guide onto the hanger bar
B: Insert core holders into your label roll
and slide loaded roll onto reel hanger bar
C: Slide other reel guide onto the hanger bar
Adjust Height
B
SIDE VIEW
A
A
B
A: Position label roll for desired placement
and tighten thumb screws
B: Feed label liner under guide bar and brush
A
B
bottle
Set Up Dispenser
strip plate
advancement roller
LAB01_Quick_Start_Guide_b072208.Page 1 8/4/2008 2:50:09 PM

AB
Continue Feeding Label Liner
START Labeling LD5000
Set Label
Quick Start Guide
LAB01
4270 Airborn Dr, Addison, TX 75001, USA
972.248.1999 | [email protected]
startinternational.com
Need more help? Download the full manual or contact us
6
5Q8.8
cyli-SIZE™
LABELER
BY START INTERNATIONAL
A: Turn handle until edge of label is 2mm
above strip plate
B: Position guide marker directly over the
gap between labels
B
A
A: Pass label liner under roller and over the strip plate
B: Pass label liner under advancement roller and over pressure roller
7
A: Place your bottle on the rollers and rotate
handle to apply label
B: Stop turning when guide marker is over
gap in next label
BA
LAB01_Quick_Start_Guide_a072208.Page 1 8/4/2008 2:51:47 PM