State Water Heaters SCI 30 YOMT User manual

RESIDENTIAL
Complies with HUD Standards for Manufactured Housing
Installation. Design-Certified by CSA International -
Also complies with National Appliance Energy Conservation Act (NAECA)
energy-efficiency standards effective January 20, 2004.
Gas Control Is Convertible for Natural and Propane Gas -
For flexibility to meet the varying needs of Manufactured Housing installations.
Side-Mounted 3/4” Cold Water Inlet - For ease of installation
when cold water supply originates below the structure. Top-mounted 3/4" hot water outlet.
Direct-Vent Models Packaged with Bottom Intake Air Vent -
To draw all combustion make-up air from outside the structure.
Optional Ducted Air Inlet Kit for Direct-Vent Models - For use when
water heater is installed over a basement. Provision for horizontal air inlet ducting up
to 30 feet, using Schedule 40 PVC pipe. Kit includes 45° rodent-proof termination
cap and wall collars. Kit #9002986 for 30 and 40 gallon models. Kit #9002987 for
50-gallon models.
Approved Roof Jack Kits Required for Installation of
Direct-Vent Models -
Four kits available to accommodate vertical vent distances from 12" to 96"
(see back of sheet).
Green Choice™ Eco-Friendly Gas Burner - Patented design reduces NOx
emissions by up to 33% and complies with Southern California and Texas requirements.
Glass-Lined Tank - For long-lasting protection against rust and corrosion.
Anode Rod - Helps protect against rust and corrosion for long life.
Factory-Installed Temperature & Pressure (T&P) Relief Valve
Maximum Hydrostatic Working Pressure 150 PSI
1-Year or 6-Year Limited Tank Warranty
®
Standard-Vent and Direct-Vent Gas Water Heaters
MANUFACTURED
HOUSING
SCOUT
For more information on Scout® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free
www.statewaterheaters.com
SMGSS00108
192241_SMGSS00108.indd 1 2/27/08 4:24:14 PM

RESIDENTIAL
GAS CONNECTOR
1/2” FEMALE
COLD
CONNECTION
3/4” FEMALE
CONNECTION
HOT
CONNECTION
3/4” FEMALE
CONNECTION
ANODE ROD
PLUG ON 30 & 40
GALLON
COLD INLET
ON 50 GALLON
T&P VALVE
®
Standard-Vent and Direct-Vent Gas Water Heaters
For complete information on limited warranties, consult written warranty,
or contact the State Customer Care Center, 1-800-365-0024.
State Industries, Inc. reserves the right to make product changes or improvements without prior notice.
Recoveries are rounded to nearest gallon.
G
MODEL PEAK ENERGY GAL. BTU INPUT RECOVERY R DIMENSIONS IN INCHES APPROX.
NUMBER DEMAND FACTOR CAP. PER HOUR 90°F RISE VALUE SHIPPING
OUTPUT NATURAL/ GALLONS A B C D E F DRAFT WEIGHT
(1st Hour PROPANE HOOD (LBS.)
Rating OUTLET
Gallons)
SCI 30 YOMT 54 0.61 30 30,000 31 16 59-1/2 56 18 15 16-3/4 51-1/4 3 115
SCI 40 YOMT 63 0.59 40 30,000 31 16 60 56-1/2 20 15 20-3/4 51-1/4 3 134
SCI 50 YOMT 77 0.58 50 38,000 39 16 62-1/4 58-3/4 22 15 20-1/2 52-1/2 3 or 4 168
STANDARD-VENT MODELS – See Figure 1
MANUFACTURED
HOUSING
Standard-Vent Models
(Figure 1)
SCOUT
69
66
88
35,000/32,000
35,500/35,500
40,000/37,000
36
37
41
8
8
8
61-3/4
59-1/4
61-1/2
57-1/4
54-3/4
57
16
18-1/2
20
13-1/4
13-1/4
13-1/4
17-3/4
17-3/4
TOP
51-1/2
48-1/2
50
3-4
3-4
3-4
For more information on Scout® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free
www.statewaterheaters.com
SMGSS00108
192241_SMGSS00108.indd 2 2/27/08 4:24:16 PM