STATESMAN CH53SS User manual

Please read these instructions carefully before use and retain for future reference.
Before switching on your appliance – Always check for any damage that may have been caused in transit.
Instruction Manual
CH53SS
53CM CANOPY HOOD
Serial number:

2
CONTENTS
Important Safety Instructions ........................................3
Specication..................................................................4
Appliance Overview.......................................................5
Installation ................................................................. 5-6
Operating Instructions...................................................7
Cleaning and Maintenance............................................8
Trouble Shooting Guide.................................................9
Fuse Replacement ......................................................10
Disposal Information ...................................................10

3
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all of the instructions even if you feel you are familiar with the product, and nd a
place to keep this manual handy for future reference.
Important: This product is intended for indoor domestic household use only.
When using electrical appliances, basic safety precautions should always be followed:
1. Only a qualied engineer can install, connect or repair this appliance. Do not install or operate
the appliance if it has been damaged.
2. Ensure the appliance is installed according to the installation instructions provided.
3. Do not change the specications or modify this appliance.
4. Before installing ensure to turn o the gas and electricity supply to the appliance.
5. Check the voltage of the appliance matches the household voltage, which is located on the
rating label. The operating voltage of the appliance is 220-240V at 50Hz. Check the rating label
and specication page for further information.
6. All appliances containing any electrical components must be earthed.
7. Cleaning and user maintenance shall not be made by children
8. Keep the appliance and its cord out of reach of children.
9. Children shall not play with the appliance.
10. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge.
11. The appliance plug must be accessible after installation. Always unplug the appliance
before cleaning.
12. Use of an extension cord is not recommended with this product.
13. The appliance is not intended to be operated by means of an external timer or remote control.
14. When disconnecting from the electricity supply, pull the plug, not the cord.
15. There should be adequate ventilation of the room when using the appliance along with other
appliances burning gas or other fuels.
16. Regular cleaning should be maintained to prevent the risk of re.
17. It is not recommended to expose the appliance to a direct heat source from cooking appliances
below i.e. naked ame from a gas burner or heat from electric hob zones without a pan on.
18. The minimum distance between the highest point on the hob top (including the burners) and the
bottom of the cooker hood is 650 mm.
19. This appliance is designed to use for 4 hobs at the most.
20. If the cooker hood is installed for use above a gas appliance then the provision for ventilation
must be in accordance with the Gas Safety Codes of Practice, the Gas Safety (Installation
& Use) Regulations, the Building Regulations issued by the Department of the Environment,
the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish
Development Department.
21. It is not recommended to ambé cook under appliance.
22. The appliance only extracts vapours and odours occurred during cooking, it does not
remove steam.
23. Ensure that the appliance is only used in accordance with the instruction manual.
24. Ensure the appliance is switched on when using the cooking appliance below otherwise
condensation may collect in the appliance and cause corrosion.
25. Ensure the structure must cover the entire cooking area.
WARNING: Do not connect the exhaust hose to an existing ventilation system that is currently
in use.

4
TECHNICAL SPECIFICATIONS - CGH60GS
Trade Mark Statesman
Model Number CH53SS
Category Type Hood
Energy Eciency Class D
Annual Energy Consumption (kWh/a) 77.5
Fluid Dynamic Eciency F
Lighting Eciency A
Grease Filter Eciency D
Time Increase Factor 1.8
Measured Air Flow Rate at Best Eciency Point (m3/h) 214.8
Measured Air Pressure at Best Eciency Point (Pa) 125
Maximum Air Flow (m3/h) 386.2
Measured Electric Power Input at Best Eciency Point (W) 114.6
Nominal Power of the Lighting System (W) 1.5x2
Average Illumination of the Lighting System on the Cooking Surface (lux) 117
Measured Power Consumption in Standby Mode (W) 0
Measured Power Consumption in O Mode (W) 0
Sound Power Level (dB) 63
Wattage Power (W) 128
Voltage (V) 230
Frequency (Hz) 50
Dimensions (mm) 520x284x279
Chimney Height (mm) /
Outlet Dimensions (mm) 150

5
APPLIANCE OVERVIEW
Lights
INSTALLATION
This appliance should only be installed by a qualied engineer. Ensure all that all masonry work
has been completed before installing the appliance and that there is enough space between the
appliance and the top of the cooking surface.
Important: Before installation, it is important to decide whether this cooker hood will be used in
extraction mode or recirculation mode.
If the extractor is to be ducted out, ensure that it is possible to connect the ducting hose.
If the extractor is to be used in recirculation mode, ensure that two carbon lters are tted on to the
hood and the canopy allows the recirculating air to be circulated from the top of the extractor and
canopy.
Carbon Filters are optional extras, they are available to be purchased from Statesman Spares
Department.
Carbon Filters are neither washable nor reusable.
Control Panel
Main Body
Grease Filter
Motor
Extraction Mode Recirculation Mode
Carbon Filter

6
• Remove the Filter from the appliance by
pressing the lock catch.
• Remove the stainless steel frame by
unscrewing the four screws (M4*10).
• Remove the screws (ST4*12) on the lid of the
terminal box, and disconnect the wires to the
control panel.
• Disconnect the wires to the light connectors.
• Fasten the appliance to the cabinet by using
the 12 screws (ST4*20).
• Replace the stainless steel frame and secure
with the removed four screws (M4*10).
Min. 650mm
497mm
13mm
259mm
150mm
410mm
256mm
245mm
284mm
492mm
520mm

7
• Reconnect the disconnect wires to the
control panel and light connectors.
• Replace the metal lter by putting in one side rst then the
other side can be gently pushed in.
• The air outlet pipe can now be connected to the
appliance and feed through the pre-drilled outlet hole
Important: Ensure the exhaust hole is not bent more than 90°
as this may aect the performance of the appliance.
OPERATING INSTRUCTIONS
Switching on the Appliance
• Plug the appliance into the mains supply.
• Press the button to select the required function;
- = O
- = Low Speed
- = Medium Speed
- = High Speed
- = Light
Important: It is recommended when frying or cooking foods with strong aromas to select the
highest speed.
Replacing the Bulb
Before maintenance ensure the appliance is disconnected
from the mains electricity supply.
• Remove the Filter from the appliance by
pressing the lock catch.
• Push out the bulb from
inside the appliance.
• Disconnect the wires to the old bulb
and reconnect the new bulb.
• Push the new bulb in to the available hole
from the outside of the appliance.

8
CLEANING AND MAINTENANCE
Before cleaning and maintenance ensure the appliance is disconnected from the mains electricity
supply.
Important: Do not allow moisture or liquids to get into the appliance.
Important: Do not use abrasive cloths, powders, household cleaners, bleach or wax polish to clean
the appliance as these can damage the appliance.
Cleaning the Exterior
• Use a clean, damp soft cloth with a little washing up liquid to wipe the exterior surface of
the appliance and dry thoroughly.
• Dry the appliance thoroughly with a clean dry cloth before connecting into the mains
electricity supply.
Cleaning the Filter
• Remove the lter by pushing in the catch on the underside of the lter, the lter can now
be removed.
• Wash the lter in warm soapy water, soaking may be necessary to help remove all the grease.
Ensure to remove all excess soap with warm water, regular washing is recommended to prevent
grease build up.
• Let the lter thoroughly dry before reinstalling in appliance.
Important: The lter may discolour after continued use or washing, this is not a cause for alarm and
the lter does not need to be replaced.
Carbon Filter
Two carbon lters can be added to the appliance (these are not included).
• Remove the metal lter by pushing in the catch on the
underside of the lter.
• Place the carbon lters on either end of the motor and
turn in a clockwise direction to lock
and anti-clockwise to remove.
• Carbon Filters are optional extras, they are available to be
purchased from Statesman Spares Department.
• Carbon Filters are neither washable nor reusable.

9
TROUBLESHOOTING
If you are having problems with your appliance, please use our troubleshooting guide below. If you
are unable to resolve the issue using this guide please ring our Customer Service Department on
0844 848 5861. Please have the model code and purchase information available.
Light on, but
motor does not
work.
The blades are blocked.
The appliance is broken. Call Customer Services;
0844 848 5861
The internal wiring is damaged,
there may be an unpleasant
smell produced.
Call Customer Services;
0844 848 5861
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective. Check fuse, replace if necessary.
Socket is defective. Mains malfunctions are to be
corrected by an electrician.
Power cut. Check that you haven’t had a
power cut or your fuse box doesn’t
need resetting.
Call Customer Services;
0844 848 5861
Fault Possible cause Solution
Appliance doesn’t
work.
Insert mains plug.
Vibration. The blade may be damaged. Call Customer Services;
0844 848 5861
Call Customer Services;
0844 848 5861
The motor needs tightening.
The appliance is loose on the
brackets.
Unplug from mains and tighten
brackets.
Insucient suction. The distance between the
appliance and the cooker top is
too large.
Check the installation instructions
and if necessary readjust the
distance.
Too much ventilation from open
doors or windows.
Reduce the amount of ventilation
until the appliance is functioning
correctly.
The appliance hangs
forward.
The screws on the installation
plates need tightening.
Tighten screws.
The xing screws need tightening. Tighten screws.

10
DISPOSAL
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in
normal unsorted municipal waste.
Old appliances must be collected separately in order to optimise the recovery and
recycling of the materials they contain and reduce the impact on human health and the
environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation,
that when you dispose of the appliance it must be separately collected. Consumers
should contact their local authority or retailer for information concerning the correct
disposal of their old appliance.
FUSE REPLACEMENT
(Moulded Plug Top – Class I)
Remove the fuse cover with a small at head screw driver.
Take out the fuse and replace with a new fuse of the
same Amp. Replace the fuse cover and push back into
place.

11

0844 848 5861
38 Bluestem Road,
Ransomes Europark
Ipswich, IP3 9RR
Disclaimer: Statesman operate a policy of continual improvement and development.
We therefore reserve the right to change/alter the specication and appearance of our appliances without prior notice.
All diagrams and images shown in this manual are for illustration purposes only.