Stealkey Customs Lian Li 011D Evo D3 User manual

1
PNr.: SW10072
EAN: 4260754980287
Lian Li 011D Evo „D3“ Montageanleitung
Assembly Instructions

Lian Li 011D Evo „D3“
2
PREPARATION - WATER LOOP PLANNING
Have a look at the port overview and plan your water loop accordingly.
The EVO D3 makes it possible to use your system also inverted. The connections remain
the same.
1.
Montageanleitung
Assembly Instructions
FILL / DRAIN
FILL / DRAIN
RADIATOR IN
CPU IN
GPU IN
RADIATOR OUT
RADIATOR IN
GPU OUT
CPU OUT
CPU OUT

Lian Li 011D Evo „D3 EVO“
3
2.
Montageanleitung
Assembly Instructions
PACKAGE CONTENTS
WARNING - This product is intended for advanced users. Improper installation may
result in damage to your equipment. While all eorts have been made to provide the most
comprehensive information possible, Stealkey Customs assumes no liability expressed
or implied for any damage(s) occurring to your components as a result of using Stealkey
Customs cooling products, either due to mistake or omission on our part in the below
instructions, or due to failure or defect in the Stealkey Customs cooling products. Do
not disassemble the water block. Warranty will be voided. Turn on the power to your
system and discharge your body’s static electric charge before proceeding with the
installation procedure. If you do not feel comfortable with performing the installation
procedure, consult a qualied computer technician.
4x M3x5
Mounting screws „D3 EVO“
RGB Cable

4
INSTALL THE DISTRIBUTION PLATE
Install the Distribution Plate in the back of the chassis. Use the 4 included M3 screws.
Do not overtighten the screws (Max 3-5 N/m).
3.
Lian Li 011D Evo „D3 EVO“ Montageanleitung
Assembly Instructions
4x M3x5 screws

5
INSTALLING FITTINGS
Install G1/4 threaded male settings and close the remaining ports with Stop Fittings.
Always perform a leak test before providing power to any system components (Max
pressure of 0,5 bar).
Allign the screw positions.
Carefully loosen the fill port stop fitting to let trapped air bleed out.
4.
CLEANING & CARE
Clean the Distribution Plate only with microfibre cloths to avoid scratching the material.
Do not use alcohol-based cleaners to avoid stress cracks in the material.
Before installing the Distrobution Plate, it is recommended to flush the distroplate to
remove the last residues.
Acrylic paints can leave residues.
5.
Lian Li 011D Evo „D3 EVO“ Montageanleitung
Assembly Instructions

6
RESERVOIR DIMENSIONS
Specifications are in mm.
6.
Lian Li 011D Evo „D3 EVO“ Montageanleitung
Assembly Instructions
31
320
120
30
54 90 100.5
19.5
62
26
32
25
48
31