STERI STAND ONE GALLON STAND User manual

Step 2Step 1
ASSEMBLY INSTRUCTIONS - ONE GALLON STAND
Also visit for instructional video:
www.steri-stand.com/assembly
The following components
are included:
-Attach Base Plate to Column with Large Bolt, Washer
and Nut.
-Make sure tips are facing down.
-Insert the Jig on top of nut.
-Wrench-tighten the bolt from below.
Base Plate Foot pedal
(White)
U clamp
Plunger Lever
Locking Pins x 2
Shelf
Wrench
Large Bolt
For Base Plate
Washer for
large bolt Nut Jig
Small screw x 2 Wingnut x 2
Rod
Column

Step 5
Step 4Step 3
Insert Plunger lever through top right slot and lock
with pin.
Insert Rod and Hook onto top notch in lever .
- Insert Pedal through bottom slot while sliding Rod.
- Hook onto bottom notch of pedal.
- Lock with Pin
Step 6 - PART 1
1. Attach U Clamp with screw hole down - insert
screw. Lightly screw Wing-nut to hold U Clamp.
2. Slide bottle onto U Clamp. Tighten bottle neck
over edge of U clamp.
3. Lift the Nozzle against plunger lever. (you may
need to loosen wing nut)
4. Now, tighten Wing nut. [this needs to go in a
box at the bottom of page 2 where there is an
empty spot -
(see diagram on next page)

Step 7
Step 8
1 2
3
4
Step 6
1
2
3
1. Attach shelf with screw and wing nut (screw hole facing down)
2. Lift the shelf to meet the bottom of the bottle
3. Tighten Wingnut
Using the notch on the supplied wrench, bend the tab on both the
plunger lever (top) and the foot pedal (bottom), securing the rod on
both sides.