Sticky Brick HYDROBRICK MAXX User manual

STICKY BRICK
HYDROBRICK MAXX
USER GUIDE
EXPERIMENT
Vapor production is dependent on several •
variables: Draw speed, flame length and
position, carb airflow, material quality and
grind, and ambient temperature.
Use of different accessories may also •
affect vapor production.
Try changing one thing at a time to help •
find your preferred method of use.
MAINTAIN
Gently clean wood components with a •
cotton swab and warm water, then dry
thoroughly. Do not clean wood parts with
ISO alcohol and only condition the wood
with Sticky Brick Butter (available for
purchase at stickybricklabs.com).
Glass components and screens should be •
removed from the Brick and cleaned with
ISO alcohol as needed.
When reassembling your Brick, insert o- •
rings into the wood before the glass for
best seal.
WARRANTY
Sticky Brick Labs offers a lifetime warranty
on wood bodies, a 15-day warranty on
glass, and will always offer replacement
parts.
CONTACT
email: [email protected]
phone: [phone]

STICKY BRICK
HYDROBRICK MAXX
~1"
INNER FLAME
OUTER FLAME
B
HEAT
INTAKE
E
C
D
SMALL BRICK
INNER LEDGE
HEAT INTAKE
O-RING
AIR INTAKE
SCREEN
CHAMBER
CARB
CARB CORK
(OPTIONAL)
18MM JOINT
O-RINGS
BASE
LID
STORAGE JAR
INTAKE STORAGE
A
PREPARE
Remove lid and set aside. Move heat •
intake from storage position to small brick.
O-ring should be placed into wood before
the glass for best seal.
Adjust torch so overall flame length is ~1". •
LOAD
Hold the base in one hand and twist the small
brick to break the magnetic connection and
expose chamber (
A
). Load ground
material loosely into chamber no higher than
the inner ledge so it evenly covers the
screen. Reassemble the Bricks.
OPERATE
Aim torch flame down heat intake, and •
position flame so the light blue outer flame
is flush with, or just inside, the intake (
B
).
Cover carb and draw slowly until you •
see/taste/feel vapor. Increase draw speed.
As you finish the draw, remove torch and •
open carb.
Stir material between draws as needed. •
Do not cover air intake on the side of the •
unit as it provides needed, continuous
airflow. Glass retains heat, so do not touch
heat intake immediately after use.
OPTIONS
The included carb cork can be used to •
block the carb to free up a hand and
produce thicker vapor.
The HydroBrick's 18mm joint is compatible •
with a variety of accessories: the included
dry mouthpiece (
C
), hydratubes (
D
),
or the included whip (
E
) to connect your
favorite glass. These items are available for
purchase at stickybricklabs.com