Sticky Brick Junior User manual

STICKY BRICK
JUNIOR
USER GUIDE
EXPERIMENT
Vapor production is dependent on several •
variables: Draw speed, flame length and
position, carb airflow, material quality and
grind, and ambient temperature.
Use of different accessories may also •
affect vapor production.
Try changing one thing at a time to help •
find your preferred method of use.
MAINTAIN
Gently clean wood components with a •
cotton swab and warm water, then dry
thoroughly. Do not clean wood parts with
ISO alcohol and only condition the wood
with Sticky Brick Butter (available for
purchase at stickybricklabs.com).
Glass components and screens should be •
removed from the Brick and cleaned with
ISO alcohol as needed.
When reassembling your Brick, insert o- •
rings into the wood before the glass for
best seal.
WARRANTY
Sticky Brick Labs offers a lifetime warranty
on wood bodies, a 15-day warranty on
glass, and will always offer replacement
parts.
CONTACT
email: [email protected]
phone: [phone]

CARB CORK
(OPTIONAL)
BASE
CARB
CHAMBER
SCREEN
TOOL PORT
AIR INTAKE
MIDSECTION
O-RINGS
HEAT INTAKE
MOUTHPIECE
LID
INNER LEDGE
STICKY BRICK
JUNIOR
~1"
INNER FLAME
OUTER FLAME
C
HEAT
INTAKE
A
B
D
E
PREPARE
Remove lid and set aside. Rotate •
mouthpiece and heat intake outward
(
A
). For roomier setup, remove
mouthpiece and insert opposite end into
midsection (
B
). Heat intake can be
angled left or right for comfort.
Adjust torch so overall flame length is ~1". •
LOAD
Separate the midsection from the base to
expose chamber. Load ground material
loosely into chamber no higher than the
inner ledge so it evenly covers the screen.
Reassemble the Bricks.
OPERATE
Aim torch flame down heat intake, and •
position flame so the light blue outer
flame is flush with, or just inside, the intake
(
C
).
Cover carb and draw slowly until you •
see/taste/feel vapor. Increase draw
speed.
As you finish the draw, remove torch and •
open carb.
Stir material between draws as needed. •
Do not cover air intake on the side of the •
unit as it provides needed, continuous
airflow. Glass retains heat, so do not
touch heat intake immediately after use.
OPTIONS
The included carb cork (
D
) can be •
used to block the carb to free up a hand
and produce thicker vapor.
The U-joint WPA (
E
) is available for •
purchase at stickybricklabs.com and lets
you connect your Sticky Brick Junior
directly to your favorite 14.4mm glass.