
Quick Start Guide
Model Number STR-DW12-W
Capacity 12 Place Settings
Warranty 3 Years In Home
Version QSG-V1.2
For more information
please visit www.stirlingappliances.com.au
or call 1300 886 649
For detailed operating instructions, please read the corresponding content
in the instruction manual.
Switching on Plug the dishwasher in, open the door and press the POWER button on the
control panel.
Adding
detergent
For each wash cycle, fill dishwasher detergent (or a
detergent tablet) into the detergent dispenser compartment
(A). For programs with prewash, also fill some detergent in
compartment (B), if using powder detergent.
Checking
rinse aid
Unless you use a detergent tablet with rinse aid, make sure
there is sufficient liquid rinse aid in the dispenser. Check the
mechanical indicator (C), or the electronic indicator on the
control panel.
Loading the
baskets Scrape off leftover food, soften burnt food residues with water, then load the
baskets following the dishwasher loading instructions.
Selecting a
program Close the door and rotate the PROGRAM knob to select the desired program.
Running the
dishwasher
Turn on the water tap. Press the START/PAUSE button to start the selected
program. The machine will start working.
Changing a
program
A running cycle canonly be modified if it has been running for a short time.
Otherwise the detergent mayhave already been released and the water already
drained. If this is the case,the detergent dispenser must be refilled.
Press and hold the START/PAUSEbutton for more than 3 seconds, then
youcan change the program to the one you wish to run. Press the START/
PAUSE button again and the dishwasher will start to work again.
Adding a
forgotten dish
To add a dish/utensil that you forgot to load into the dishwasher,
press the START/PAUSE button, open the doora little and,
when the spray arm stop working, open it completely. Add the
forgottendish, close the door, press the START/PAUSE button
and the dishwasher will start to work again after about 10 seconds.
Power
disruption
during use
If the appliance is switched off or loses power during a wash cycle, when
switched on again, please re-select the washing program and operate the
dishwasher according to the original power-on state.
Shutting down
When the washing cycle is finished, the buzzer will sound several times and then
stop. Press the POWER buttonto shut down the unit.Open the door slightly to
help withthe drying process — take care as hot steam may escape!
After use
Wait about 15 minutes before unloading the dishwasherto avoid scalding, as
the dishes and utensils are still hot and more susceptible to break. Theywill also
dry better. Unload the dishwasher, starting from the lower basket.
Turn off the power at the outlet, close the water tap and leave the dishwasher
door slightlyajar to let residual moisture evaporate.
AB
C
WARNING:
Openthe door
carefully, hot
steam may
escape!
ä
ä
ä
ä
ä
ä
ä
ä