STKR FLEXIT Headlamp PRO User manual

SAFETY WARNING: This product contains high intensity LED devices. To prevent permanent eye
damage, do not stare into the light beam at close range.
SPECIFICATIONS
Model # 00387
650 Total True Lumens
IPX6 Waterproof Rating
5.8oz (battery incl.)
QUESTIONS? Before returning to your retailer, call our customer service department at
704-508-1031, 8 a.m. - 5 p.m. ET, Monday - Friday or email us at [e-mail]
Spotlight
Button
Flood Light
Button
Flood Light
(white/red)
Red Light
Button
Spotlight
Rear Red
Hazard Light
Battery Case
RED LIGHT
Red light button controls rear hazard
safety light and front red ood lights
Press button to turn ON
Press to cycle through modes:
1. Rear Red-Light
2. Rear Flashing Red-Light
3. Rear Red-Light + Front Red Flood
Light
4. OFF
Press & HOLD to turn on 360°
Flashing Red Hazard Safety Light
Mode.
After 5 seconds of no mode changes,
press button to turn red light o
SPOTLIGHT & FLOOD LIGHT
The spotlight & ood lights
are independently controlled
Press button to turn ON or
OFF
Press & HOLD to increase/
decrease brightness.
note: the light blinks to
indicate when the brightness
level has reached minimum
or maximum
FEATURES
Positionable Spotlight
Center CREE LED
Outer Flood COB LEDs
(White & Red Light)
180° Halo Lighting
Rear Red Hazard Light
OPERATION

Included: (1x) FLEXIT Headlamp PRO, (1x) 18650 Lithium-ion, (1x) Micro-USB cable, (1x) Carry pouch
Model # 00387
1 Year warranty
Troutman, NC | 704-508-1031 | [e-mail] | STKRconcepts.com
BATTERY INSTALLATION
1) Pull tab to open battery case 2) Place 1x 18650
Lithium-ion rechargeable battery into the battery terminal.
KILL SWITCH
Prevent headlamp from accidentally turning on during
transportation.
POWER ON: Open battery case and slide kill switch to the
LEFT position to provide power to the headlamp.
POWER OFF: Open battery case and slide kill switch to the
RIGHT position to turn power o to headlamp.
PATENT PENDING
CLEAN & CARE
Hand-wash Foam & Strap with mild soap.
Do not submerge in water. Not machine washable.
Strap
Comfort Fit
Foam
Open Tab
Battery
Micro-USB
port
Battery Level
Indicator
CHARGING
1) Plug the micro-USB cable into the micro-USB port 2)
plug the other end of the cable into a USB wall charger*,
USB car charger*, or any other USB charging device* (e.g.
computer). *Not included. *Charger output of 1A to 2.1A is
recommended. Charger output should NOT exceed 2.1A
to prevent battery damage.
- - Battery Level Indicator lights blink while charging then
solid glow when fully charged.
**Please recharge a stored unit every four months to
maintain optimum performance of the lithium-ion batteries
and maximize charging levels. Battery excl. from warranty.
Kill Switch
(shown in the POWER
ON position, slide to
the right to POWER
OFF)
+
_