STONE FORAS Belmont Pebble Pool User manual

The Belmont Pebble Pool water feature is available in two sizes: 30cm or 40cm ball. The kit can
be used recessed into a flower bed or incorporated into a patio.
The kit contains: 65cm reservoir, pump 800 litres per
hour with 10m of cable, plug, 20mm water pipe, 20/25
pipe adapter, ball and a 25kg bag of pebbles. Check
the kit before installation.
2: Place the pump in the reservoir, then run the power cable up and over the
lip of the reservoir and out to the required power supply (this could be fed
through an underground pipe that leads to the feature from a power source).
Place top on reservoir, leaving the inspection hatch cover off. See diagram A.
Belmont Pebble Pool
Water Feature Kit
Instructions
Cont:-
Belmont Pebble Pool Water Feature Kit
The Pebble Pool can be installed above ground (with a
brick surround) or below ground as per our diagrams.
There are some important details that need to be
followed. Please read the instructions carefully before
installation, if you are unsure of any details please
contact your local stockist or the Foras team for further
help.
1: Having installed the reservoir into the ground, follow our step by step guide for
installation.
A

3: Place the support ring on the top of
reservoir. See Picture 1. Feed the
20mm water pipe down through the
ring and into the reservoir connecting
to the outlet on the pump. Place some
packaging or a wooden block on the
lip of the reservoir to protect it. Then
roll the ball up to the edge of the ring,
and feed the water pipe up through
the ball to leave a few inches out the
top. See Picture 2.
See Diagram B.
4: Roll the ball up onto the support ring, taking care not to nip the pipe (two people are needed to place the
40cm ball). Adjust the ball so the hole is in the middle as this will allow the water to flow evenly over the ball.
See Picture 3.
Cont:-
Cont:-
5: Connect the nozzle to the 20mm water pipe and push
access pipe and nozzle down into the ball. See Picture 4
and 5.
B
1
2
3
4
5
6: Cover the service hatch with plastic cover. Dress the
reservoir top with the bag of pebbles.

8: Fill the reservoir with water and switch on the pump.
The pump can be adjusted to obtain the required flow
rate by accessing through the service hatch and
adjusting the pump. In a windy location reducing the
flow rate will avoid the water blowing off the ball.
Foras cleaning kits are
available to help prevent
algae build up, and help
keep the stone and water
clean.
During the winter the pump should be switched off to protect
from frost in an insulated bag then returned into the support
pipe and the ball replaced ready for an easy start in the
spring. Visit our website or contact the Foras team for full
details.
Installation Diagram
Foras, West Head Farm, Stowbridge, Kings Lynn, Norfolk, PE34 3NJ
www.foras.co.uk email: [email protected].
7: Connect the wires to the plugs.
Cont:-
For further help and support on Foras products call our office on 01366 381069
Important Note. WARNING!
Belmont balls are heavy. Take extra care when moving
them.
Take care not to nip water pipe when placing ball on ring.