ASC SF017 User manual

1
SF017 Solar Pedestal & Ball Instructions
By All Solar Central
www.allsolarcentral.com
Thank you rom the entire ASC amily or purchasing
an ASC solar product! Please read this entire booklet
be ore assembly.
Package contents:
1 x Ball
1 x Pedestal With Rubber Bung
1 x Water Pump
1 x Solar Panel
1 x Solar Panel Bracket
1 x Extension Tube
1 x Ground Spike
Notes: I there is any damage to the product or missing
parts, please contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus
Assembly Steps:
1. Feed the pump cable and LED Light cable through
the tube in the Rattan Pillar Reservoir and exit
rom the bottom o the Fountain Body. Then, use
the provided Rubber Bung to seal the tube hole
to avoid water leaking.
2. Fill reservoir with appropriate amount o water to
ully submerse the pump.
3. Attach the pump to the Rubber Hose.
4. Place the Ball and the Pump onto the Pedestal.

2
5. Connect the bracket, tubes and spike together.
Then attach the solar panel to the bracket. Slide
the holding bracket into the inside lip o the top
hal o the solar panel rame. The bracket holds
the weight o the solar panel. The solar panel can
be adjusted or optimal sunlight by using the
wingnut. Please see the diagram.
6. Insert the spike into the ground. Position the
solar panel so it’s acing south (in northern
hemisphere) as much as possible to maximize
daylight hours. It is important to angle the solar
panel to ace the sun when the sun is at its
highest point. Ensure the solar panel is not
shaded by trees, shrubs or buildings.
7. Connect the Pump to the back side o the Solar
Panel. IMPORTANT!! Slightly twist the connectors
when connecting to make sure the rubber seals
are ully in the grooves.
Notes: Your Solar Pump Kit might vary. Please
re er to the Solar Water Pump Kit Instructions or
more in ormation.
8. Now your new ountain is assembled and ready
to use.
Please visit www.allsolarcentral.com or more
products and o ers.