
1. Open Lid to fill.
5. Use On/Off trigger to
control spray.
6. Adjust Nozzle at end
for either Fine Mist or
Direct Spray.
2. Do not exceed maximum
filling level 5 Litres.
3. Pump handle to generate
pressure. Max 25 pumps.
7. Always release pressure
when job is finished and
empty bottle of excess liquid.
Always wash thoroughly
after using chemical sprays.
General/Usage instructions for use.
Please note:
It is essential before using your
Power Washer to ensure that
the Tab (A) is firmly secured
under the Lip (B), see diagram.
To secure, push down the handle
(if required) twist the Tab (A)
using the handle in the direction
of the arrow until it is fully
secured under the lip (B)
Streetwize Accessories: Unit 1, Royce Trading Estate, Ashburton Road West, Trafford Park, Manchester M17 1RY
4. Safety pressure relief
valve will activate if max
pressure is reached.
It is recomended that this power sprayer is restriced in use to water-based
products and certain chemicals identified asharmful or irritant and/or carry
the following labels. When using paints, stains, pesticides and other water
solluble harmful substances, always observe the instructions and refer to
the Safety Data Sheets of the fluids that are being used.
ADVISORY WARNING: It is recommended that this equipment is NOT used for solvent paints, VOC’s and
chemicals hazardous to health.
This includes any chemicals
identified as Flammable, Oxidising
Corrosive or Acutely Toxic and/or
which carry the following symbols.
B
A
A
B
SWPW3 Manual AW 2018.qxp_Layout 1 18/07/2018 15:11 Page 2