Strut King SK06-HPDL-RMT01 User manual

1 of 2
Installation Instructions
02’+ RSX Sport Pedals (Manual)
SK06-HPDL-RMT01
1.
2.
ontents: 1x Gas Pedal 10x Self-tapping screws
1x Footrest 8x Bolts ( short, 2 long)
2x Brake/Clutch Pedal 8x Locking Nuts
2x Brake/Clutch Rubber Insert 2x Drill Bit
Tools Required: 7mm socket wrench, Phillips screw driver or power drill with Phillips attachment
Disclaimer: Please use caution and proper safety equipment when using power tools, Strut King
and its affiliates are not responsible for any injuries occurred during installation.
Place the stainless steel gas pedal cover
over the existing plastic pedal. Using the
power drill, drill 4 holes where at the
mounting locations on the pedal. Install the
two self-tapping screw onto the top
locations. The bottom two holes require
the use of the longer bolts & nuts. They
should extend out the opposite end just
enough for the nuts. The self tapping screws
can be used on the bottom two mounting
locations but the use of nuts & bolts are
highly suggested.
Remove the stock rubber pads on the
brake & clutch pedal.

2 of 2
3.
4.
5.
Place one of the brake/clutch pedals
over the clutch to use as a template.
Using the provided drill bit, drill the 3 holes
needed.
The brake pedal has existing holes that
need to be enlarged. Using the provided
drill bit, enlarge the existing holes to the
needed size.
Using the bolt and locking nut, secure
the brake & clutch pedals using a Phillips
screw driver and 7mm socket wrench to
tighten.
Place the stainless steel footrest over your existing
footrest and use the self-tapping screws to install on the
locations shown on the picture. Use a Phillips
screwdriver or a power drill with Phillips attachment to
properly mount the footrest.