StudioDesk MSWH01 User manual

MSWH01 PRO tower speaker stand white
MSBL01 PRO tower speaker stand black
Please assemble your product on soft
surface to avoid scratches and damages
on lacquer.
!
www.studiodesk.net

The Desk You Deserve
ThankyouformakingStudioDeskyourdeskofchoice!
Before beginning assembly of your stand, let’s get familiar with the parts you have received in your package.
Please match the corresponding numbers on this page with the drawings.
1. Body
2. Base
3. Neck
4. Top shelf
Hardware
Wooden parts
Tools needed (Not included)
9
Desk tips
4 pcs
10
M6 Screw
2 pcs
11 12
Wooden Dowels
8 pcs
2 4
3
1
L R
L
R
LockFi30
Washer
13
2 pcs

1 Step One
Insert dowels (12) into the holes as
shown in the illustration. Use a
rubber hammer if needed.
3 Step Three
Place body part to the base as shown
on the illustration on the right.
11
4 Step Four
Place neck part (3) and speaker shelf (4) on
corresponding dowels and press it down until it
comes to the place firmly.
2 Step Two
Install tips to the base by
screwing them in predefined
place.
www.studiodesk.net

5 Step Five
Once dowels are in place and body sit tight to the leg,
use M6 screws and washers to fix base to the body.
Step Six
7 Step Seven
Fasten screws on the back to finish your
speaker stand.
8 Step Eight
Adjust desired height of the shelf and lock it
with the metal lock. Lock should freely be
pushed trough body and neck until is in same
level with the body surface from the both
sides.
NOTE: Maximum safe load per speaker stand is 15 kg.