Summer LIL' LUXURIES 18930 User manual

Shower, Bubbling Spa & Whirlpool Unit
1. To remove Shower, Bubbling Spa & Whirlpool Unit
lid, hold top of lid and push reservoir back until you hear
a click (Figure A).
Pull lid from the back edge until it releases.
2. Use screwdriver to open battery compartment door (Figure B).
3. Insert 4 new alkaline “D”batteries into battery compartment.
• Be sure to install the batteries properly and in the right direction.
• The battery compartment is marked with + and –.
• Make sure the markings on the batteries match the markings on
the battery compartment (Figure C).
4. Close battery compartment doors
and tighten the 2 screws.
DO NOT OVERTIGHTEN.
Proper Lid Assembly
1. Attach lid onto reservoir.
• Be sure to rmly push lid down
until you hear a loud click on
both sides (Figure D).
• Make sure the lid is on tight by gently pulling up on either end.
• Lid should not lift up o reservoir.
NOTE: Front portion of lid will not lock shut; it will close
when tub and unit are assembled.
•Locking the back portion of the lid onto the reservoir is critical
for proper bubble performance.
• Do not lift by the lid.
•Lift from bottom of reservoir to prevent any spills.
1. Remove lid and ll
with clean water.
Do not exceed max ll line
inside of reservoir (Figure G).
CAUTION: Do not carry lled
reservoir by the lid.
2. Attach the Shower, Bubbling Spa & Whirlpool Unit onto outside of tub.
Be sure unit is aligned correctly to allow maximum air ow to Bubble Track (Figure H).
NOTE:
• Never place more than 1" of water in the tub.
• Always keep the drain open in the adult bath tub or sink.
SETTING UP BUBBLE TRACK & SPA CONNECTOR
USING THE SHOWER,BUBBLING SPA & WHIRLPOOL UNIT
45
INSTALLING THE BATTERIES
F
A
D
B C
G
Bubble Track
1. Line rubber Bubble Track into channels on
bottom of the tub (Figure E).
2. Start in the back of the tub and work the Bubbling Track into
the slots, working forward toward the tub’s drain plug.
Spa Connector
1. Attach the Spa Connector to the tub wall.
2. Snap the top of the Spa Connector piece into the top
of the tub wall (Figure F).
E
H
Shower Mode
• To turn shower on, press left button 1 time
•To turn o, press the left
button 1 more time (Figure I).
Bubbling Spa Mode
• To turn bubbles on, press the right button 1 time.
• To turn bubbles o, press the right button 2 more times until bubbles shut o (Figure I).
NOTE:
Allow a few moments for maximum bubbling action.
No bubbles? See Tips & Troubleshooting on Page 8.
Whirlpool Mode
• Press the right button 2 times to turn the Whirlpool on.
• To turn o, press the right button 1 more time (Figure I).
Shower
Bubbling Spa
Whirlpool
I
IMPORTANT NOTE: When in whirlpool mode, the whirlpool
nozzle may become misaligned when the reservoir lid is
reinstalled onto the reservoir. This is not a product defect.
Please remove the reservoir lid and readjust the whirlpool nozzle
to the correct location for sucient whirlpool function.