SUMS uridan ADMIRAL GV-10 User manual

GV-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instructions
Parts List |
Fitting Kit |
1 x fitting No. 1
2
x 45
° bend
1
x uriLOCK 0
.
3 L
1 x uriCLEAN 0.5 L
1 x uriCLOTH 1 x Cover
1 x suction device
2 x screws fitting No. 1
Note |
Installation of the uridan waterless urinal is very
simple.
If you are retrofitting existing flushing urinals with uridan
waterless urinals, please ensure that the sewer line is jetted
and clean of uric scale before installation.
Please also remove any existing s-trap to avoid double
trapping the urinal.
The uridan urinals work without water, and must be fitted to
a 50mm waste pipe. Installation should be carried out by
authorized plumbers in accordance with AZ/NZS3500.2.
PLEASE NOTE: The undiluted discharge from a waterless
urinal must not be transported through copper or copper alloy
pipework.

GV-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instructions
ADMIRAL GV-10
glass reinforced plastic (GRP) | vertical
Installation
1. Mark holes for fitting No. (1) and install.
2. Mount the wastewater pipes using the sketch. Hold the urinal against the wall and push firmly onto fitting No. (1).
3. Fill the waste trap (Position B) with water.
4. Insert the stainless steel cover (Position A).
5. Pour 1 bottle uriLOCK ( 0.3 liter) over the cover.
6. Seal the gap between the wall and the urinal with silicone. Please note: Do not put silicone on the lower tip of the
urinal!
The uridan urinal is now ready for use!
Please leave customer care booklet, cleaning and maintenance instructions,
cleaning spray, cleaning cloth and suction device with customer.