SUMS uridan COMPASS GY-W User manual

GY-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instructions
Parts List |
Fitting Kit |
*Toilet seat packed separately – incl. installation instructions
2 x fitting No. 20
1
x uriLOCK 0
.
3 L
1 x uriCLEAN 0.5 L
1 x uriCLOTH 1 x Cover
1 x suction device
Note |
EN If you are retrofitting existing flushing urinals with uridan waterless urinals, please ensure that the sewer line
is jetted and clean of uric scale before installation. Please also remove any existing s-trap to avoid double trapping
the urinal.
The uridan urinals work without water and the urinals should be fitted to a 50 mm waste pipe.
Installation should be carried out by authorized plumbers in accordance with AZ/NZ3500.2.
PLEASE NOTE: The undiluted discharge from a waterless urinal must not be transported through copper or copper
alloy pipework.
4
x screws fitting No. 20

GY-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instructions
COMPASS GY-W
glass reinforced plastic (GRP) | vertical waste
Installation
1. Mark holes for fitting No. (20) and install.
2. Hold the urinal against the wall and push firmly onto fitting No. (20). Slide the urinal down to connect to the
50mm waste outlet.
3. Fill the waste trap (Position B) with water.
4. Insert the stainless-steel cover (Position A).
5. Pour 1 bottle uriLOCK (0.3 litre) over the cover.
6. Apply silicon sealant around the edge of the urinal – between urinal wall & floor.
The uridan urinal is now ready for use!
Please leave customer care booklet, cleaning and maintenance instructions,
cleaning spray, cleaning cloth and suction device with customer.