SUMS uridan CADET KVC-10 User manual

KVC-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instruction
Parts List |
Fitting Kit |
2
x screws No. 19
1
x uriLOCK 0
.
3 L
1
x uriCLEAN
0.5 L
1 x uriCLOTH 1 x Cover
1 x suction device
2 x 45° bend
Note |
Installation of the uridan waterless urinal is very
simple.
If you are retrofitting existing flushing urinals with uridan
waterless urinals, please ensure that the sewer line is jetted
and clean of uric scale before installation. Please also remove
any existing s-trap to avoid double trapping the urinal.
The uridan urinals work without water, and must be fitted to
a 50mm waste pipe. Installation should be carried out by
authorized plumbers in accordance with AZ/NZS3500.2.
PLEASE NOTE: The undiluted discharge from a waterless
urinal must not be transported through copper or copper
alloy pipework.

KVC-10 Installation Instructions – May 2020 www.uridanaustralia.com.au
Installation Instruction
CADET KVC-10
ceramic | vertical
Installation
1. Measure the distacne from the floor and mark holes for fitting No. (19). Drill holes and mount fitting No. (19).
2. Mount the wastewater pipe as per the drawing. The distance from the wall to center of the pipe should be close to 107
mm.
3. Hold the urinal against the wall and push firmly onto the fitting No. (19). Ensure the waste pipe connection is
maintained.
Please note: Between urinal and wall should be a gap of approx. 2 to 5 mm, so that tension cracks can be prevented.
4. Fill the waste trap (Position B) full with water.
5. Insert the stainless steel cover (Position A).
6. Pour 1 bottle uriLOCK ( 0.3 litre) over the cover.
7. Seal the gap between the wall and the urinal with silicone.
The uridan urinal is now ready for use!
Please leave customer care booklet, cleaning and maintenance instructions,
cleaning spray, cleaning cloth and suction device with customer.