sunjoe SJ-BZ15W-BLK User manual

Form No. SJ-SJ-BZ15W-BLK-880E-M
If you have any questions or comments,
please call the Snow Joe®+ Sun Joe®customer service department at:
1-866-SNOWJOE (1-866-766-9563)
© 2022 by Snow Joe®, LLC
All rights reserved. Original instructions. SAVE THESE INSTRUCTIONS
5W ELECTRIC BUG TRAPPER
UV LIGHT | FAN | GLUE BOARD
Model SJ-BZ15W-BLK
R
1
EN

2
IMPORTANT!
Safety Instructions
Read all the instructions
before using the device
mWARNING! This device is not
intended for use by children or by unassisted,
unsupervised persons whose physical, sensory
or mental capabilities prevent them from using it
safely. Children should be supervised to ensure
that they do not play with the device.
mWARNING! When using the device,
basic safety precautions should always be
followed. Failure to follow all instructions listed
below may result in electric shock, re and/or
serious injury.
• This device is for indoor, household use
only.
• Do not operate the device in explosive
atmospheres, such as in the presence of
ammable liquids, gases or dust.
• Do not insert foreign objects into this
device.
• To reduce the risk of electric shock,
disconnect the device from the power
supply when not in use, cleaning, or other
similar actions. To disconnect, turn o
before unplugging the device from the
outlet.
• Do not operate the device with a damaged
USB adapter or power cable, or after
the device malfunctions, is dropped or
damaged in any manner. Contact the Snow
Joe®+ Sun Joe®customer service center
at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
• Keep all connections dry and o the
ground.
• Do not clean this device with cleaning
agents or solvents as they may damage,
weaken or destroy the plastic housing.
• Do not contact moving parts.
• Do not spray or wash in water. Do not use
with wet hands or in damp environments.
• Do not immerse this device or place it
where it can fall or be pulled into a tub or
sink.
• Store the device indoors and out of the
reach of children when not in use.
• When unplugging the power cable from the
device or the USB adapter, pull the plug,
not the cable to reduce the risk of damage
to the power cable.
• For use only with 5V DC, 2A UL or ETL
rated adapters. Do not use unapproved
power sources.
• Keep the power cable away from heat,
oil and sharp edges. Make sure the cable
is not be stepped on, tripped over or
subjected to stress when in use.
• Use only identical replacement parts and
attachments sold by the manufacturer.
Replace or repair damaged parts
immediately.
• If the device is malfunctioning,
unplug it and contact Snow Joe®+
Sun Joe®customer service center at
1-866-SNOWJOE (1-866-766-9563).
mCAUTION! Risk of UV exposure. Ensure
product is installed such that no continuous
human activity is likely to be performed within
0.99m distance of the unit while illuminated.
SAVE THESE INSTRUCTIONS

3
Know Your Electric Bug Trapper
Read the owner’s manual and safety rules carefully before using your Electric Bug Trapper. Compare
the illustration below to the actual unit in order to familiarize yourself with the location of the various
controls and adjustments. Save this manual for future reference.
Technical Data
Bug Trapper Input....................... 5V DC | 1A | 5 W
AC Adapter Input............................ 100 - 240V AC
50/60 Hz | 0.35A
AC Adapter Output (USB) ................... 5V DC | 2A
Modes ......................................Dimmed / Regular
Glue Board Diameter......................4.3 in. (11 cm)
Power Cable Length............................ 4 ft. (1.2m)
Net Weight....................................0.95 lbs (430 g)
1
2 3
4 5
6 7 8 9 1110
1. Replacement
glue boards
2. Power button
3. Mode button
4. UV LED
5. Handle
6. USB adapter
7. Cleaning brush
8. Power cable
9. Tray
10. Air outlet
11. Tray release button

4
2. Press the tray release button to unlock the
tray at the bottom of the bug trapper. Then
place the glue board with the sticky side up
onto the inside of the tray (Fig. 2).
3. Close the tray.
Operation
Intended Use
The SJ-BZ15W-BLK electric bug trapper is
designed to trap and collect various small ying
insects such as mosquitoes, fruit ies, gnats,
moths and more.
This product is intended for indoor domestic
use only. It is not intended for commercial use.
It must not be used for any purposes other than
those described.
Powering the Bug Trapper (Fig. 3)
1. Connect the included power cable into the
USB port of the USB adapter.
2. Plug the USB adapter into an appropriate
electrical outlet.
3. Plug the other end of the power cable into
the power socket on the back of the bug
trapper.
Fig. 2
Glue board
Tray
release
button
Fig. 3
USB adapter
Power
socket
Power
cable
Unpacking
Carton Contents
• Electric bug trapper
• Replacement glue boards (x10)
• AC adapter
• Power cable
• Cleaning brush
• Manual and registration card
1. Carefully remove the electric bug trapper
and check to see that all of the above items
are supplied.
2. Inspect the product carefully to make
sure no breakage or damage occurred
during shipping. If you nd damaged or
missing parts, DO NOT return the unit
to the store. Please call the Snow Joe®
+ Sun Joe®customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton
and packaging material until you are ready
to use your new electric bug trapper. The
packaging is made of recyclable materials.
Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and
packaging material are not toys. Do not
let children play with plastic bags, foils, or
small parts. These items can be swallowed
and pose a suocation risk!
mWARNING! To reduce the risk of
injury, the user must read and understand this
operator’s manual before using this product.
Failure to follow all warnings and precautions
may result in personal injury, or property
damage.
Installing Glue Board
1. Peel the paper backing from the glue board
(Fig. 1).
Fig. 1 Glue board
Paper backing

5
Modes (Fig. 4)
1. Press the power button to turn the device
on or o.
2. Press the mode button to cycle between
two operating modes.
• Fan + UV (dimmed)
• Fan + UV (regular)
3. Simply leave the bug trapper running in an
indoor environment. The UV light will attract
insects to the device allowing the fan to
suck them down onto the glue board.
NOTE: For best results, use in a dark
enclosed space away from strong fan or air
conditioning drafts.
Maintenance
Replacing the Glue Board
Replace the glue board with the included
replacements once it has been suciently
saturated with insects. Refer to Fig. 2 for
instructions on installing a new glue board.
Cleaning
1. Unplug the bug trapper then press the tray
release button to open the tray.
2. Use the included cleaning brush to clean
the funnel and tray (Fig. 5).
Fig. 4 Power button
Mode button
Fig. 5
Funnel
Cleaning
brush
Tray
mWARNING! The exterior housing of
bug trapper does not require cleaning. Do not
attempt to clean the housing with water, solvents
or any other liquids.
Service + Support
If your Sun Joe®SJ-BZ15W-BLK 5W Electric
Bug Trapper requires service or maintenance,
please call Snow Joe®+ Sun Joe®customer
service at 1-866-SNOWJOE (1-866-766-9563)
for assistance.
Model + Serial Numbers
When contacting the company or arranging
service from an authorized dealer, you will need
to provide the model and serial numbers, which
can be found on the registration card. Copy
these numbers into the space provided below.
Record the following numbers from the registration card
of your new product:
Model #:
Serial #:
S J -
B Z 1 5 W - B L K