EN
Maintenance + Care
Follow the steps below if the sprinkler stops working or
exhibits poor water quality due to debris or dirt build-up.
1. Remove the inlet lter from the hose-end of the oscillator
and run under water (Fig. 3).
2. Remove the cleaning pin from the opposite end of the
oscillator (Fig. 4).
3. To ush, connect the oscillator to a spigot. Turn on the
faucet and while the water continues running, spin the
tube gently back and forth for few minutes. Then screw
the inlet lter rmly back in place (Fig. 5)
Fig. 5
hose-end
tube
4. Use the provided cleaning pin to clear any clogs from the
spray nozzles. Fit cleaning pin rmly back in place before
using the sprinkler (Fig. 6).
Storage
Drain the sprinkler after use. DO NOT allow water to freeze in
the sprinkler (Fig. 7).
Fig. 7
Model + Serial Numbers
When contacting the company or arranging service from an
authorized dealer, you will need to provide the model and serial
numbers, which can be found on the decal located on the
sprinkler. Copy these numbers into the space provided below.
Record the following numbers from the housing or handle of your
new product: Model #:
Serial #:
S J I - O M S 1 6
Fig. 3
inlet lter
hose-end
inlet
lter
Fig. 4
cleaning
pin
cleaning pin
Fig. 6
3
Discover other outdoor tools & equipment on our website.
