Sunjoy L-CM057PST-B-CA User manual

Assembly Instruction
Steel fireplace-B
Item# L-CM057PST-B-CA
SAFETY INFORMATION:
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNINGS:
FOR OUTDOOR USE ONLY! NEVER LEAVE FIRE UNATTENDED! Do not allow children or pets near
the fireplace without supervision. The fireplace is not designed for cooking food.
CAUTIONS:
Burn only wood or charcoal in the fireplace. DO NOT use gasoline or kerosene to start the fire in your
fireplace. Use only an acceptable method of lighting the fire, such as match and lighter. DO NOT use this
unit on a wood deck or on combustible surfaces such as dry grass, leaves, mulch, etc. The fireplace
should be placed no closer than 5 feet from walls during use. DO NOT attempt to move the fireplace
while it is hot or in use. Do NOT put woods on the grill grate.
PREPARATION:
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble the
product. Contact customer service for replacement parts

No. Description Qty
A Chimney top 1
B Upper base 1
C Rear board 1
D Side mesh 2
E Door 1
F Handle 1
F1 Handle plate 1
G Grill Grate 1
H Grate 1
I Fire bowl 1
J Ash tray 1
K Base 1
L Poker 1
Part Description Qty
AA M6 Nut 11
BB M6*15 Bolt 8
CC M6 Washer 19
DD M5*10 Bolt 3
EE M5 Nut 3
FF M5/M6 Wrench 1
Part List
Part List

Attach side mesh (D) to base (K) by using nuts (AA) and
flat washers (CC). Do not fully tighten the connections in
this step..
Step 1: Step 2:
Step 3: Step 4:
Connect rear board (C) and side mesh (D) by using bolts
(BB) and
washers (CC). Do not fully tighten the
connections in this step. Connect the door and the side
mesh by the same way.
Connect fire bowl (I) and ash tray (J) by using bolts (DD)
and nuts (EE).Fully tighten all connections as shown.
Connect upper base (B) and chimney top (A) by using
nuts (AA) and flat washers (CC).Do not fully tighten all
the connections in this step.

Connect upper base (B) and side mesh (D) by using nuts
(AA) and washers (CC). Fully tighten all connections.
Connect handle (F) and handle plate (F1) by using nuts
(AA) and washers (CC).Fully tighten the connections
Open the door, put the grill grate (G), grate (H), fire bowl (I) on
the base (K) as shown.
Step 5: Step 6:
Step 7:
Close the door and put the poker (L) aside for further
use.
Step 8: