Sunrich Tech C-430 User manual

eSATA II 300 1-Port ExpressCard
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN7000000064 Page2
Features and Benefits
Fully compliant with ExpressCard Specification 1.0
ExpressCard/34 Form Factor Module
Serial ATA generation 2 transfer rate of 3.0Gbps
One eSATA (external Serial ATA) port
Supports hot plug for external Serial ATA port
Support SATA II NCQ (Native Command Queuing) to maximize
system performance
Supports Windows® 2000, XP/2003/Vista (32-bit and 64-bit)
System Requirements
Windows® 2000, XP/2003/Vista (32-bit and 64-bit)
ExpressCard-enabled system with an available ExpressCard slot
Package Contents
1 x eSATA II 300 1-Port ExpressCard
1 x Driver CD
1 x User Manual
Hardware Installation

MN7000000064 Page3
General instructions for installing the card are provided below. Since
the design of system may vary, refer to your system’s reference manual
for further information, if needed.
Insert the Card into the ExpressCard slot of your system. Make sure it
is inserted all the way in for a solid connection.
Driver Installation
1. Please insert the CD driver bound with eSATA II 300 1-Port
ExpressCard into your CD-ROM Drive.
2. At the Windows desktop, click Start, Run.
3. Type D:\ExpressCard\SiI3531\Setup.exe, click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Look for the following:
Windows® 2000/XP/2003: Double click SCSI and RAID
Controller:

-Silicon Image SiI 3531 SATA Controller should be displayed
Windows® Vista: Double click Storage controllers:
-Silicon Image SiI 3531 SATA Controller should be displayed
Hot-Plugging Hard Disk Drives
To remove a drive from a powered up system, do the following:
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Click Disk Drives, right click the target disk and select
Disable/Enable.
4. You can now remove the target disk.