WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
4Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2” screws.
Locate the Body Fan Endcap packaged with the Bench.
It can be identified by the slots for the body fan.
2Remove the two 1/4-20 x 1/2”
screws in the bracket. Again,
save these screws.
pg. 1 26795-02A
3Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.
Installing the Body Fan on a SUNSTAR 332 and 432
You will need a #2 Phillips screwdriver to perform this procedure.
1Open the bench acrylic. At the foot
end, inside the lamp area, remove
the four screws securing the body
fan bracket to the metal endcap. Save
these screws.
