SunStar ZX32 Instruction Manual

WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
3Slip the Body Fan into
the Body Fan Endcap,
as shown. Be sure to
insert the wire connector
into the rectangular hole
and route the wire in the
groove in the Body Fan
Bracket.
2Remove the two screws shown
and use them to attach the Body
Fan Mounting Bracket in the same
holes the screws came out of.
Install the #10 x 1/2” screws in the
upper two holes of the bracket.
Removed from unit 24735-01A
Installing the Body Fan on a SUNSTAR ZX32
You will need a #2 Phillips screwdriver to perform this procedure.
In this kit you should find the following parts:
(2) - #10 x 1/2” Phillips pan head
sheet metal screws
(2) - 1/4-20 x 1/2” Phillips pan head
machine screws with lock washer
Body Fan
Mounting Bracket
Body Fan
Body Fan
Endcap
1Open the bench acrylic shield and
remove the Foot End Bench Endcap
by removing the four screws that
hold it in place. Save these screws
to install the new endcap.

5Working from the inside of the bench,
fasten the Body Fan Bracket to the
Body Fan Mounting Bracket with the
(2) 1/4-20 x 1/2” screws.
6Tighten the screws holding
the endcap on and close
the bench acrylic.
4Holding the Endcap and Body Fan together,
connect the Body Fan power cord to the cord
coming out of the end of the bench. Then, pull
the Body Fan almost out of the endcap as you
put the endcap in place and drop the Body Fan
into the Body Fan Mounting Bracket. Using the
screws removed from the old endcap, loosely
attach the new endcap to the bed. Start all four
screws in their holes only a few turns.