Sunsystem Sun Stand 2 User manual

A
B
C
D
Sun Stand™ 2
HEAVY DUTY H.I.D. AND FLUORESCENT LIGHT STAND
ASSEMBLY INSTRUCTIONS
This unit contains:
Parts to Assemble Sun Stand™2 Parts to hang column
Qty Description Qty Description
1 ea Top bar (A) 2 ea Grow Yo-Yo’s
2 ea Side upright bars (B) 2 ea Hanging shuttles
2 ea Feet (C)
36 ea ¼-20 x 3⁄8” screws
4 ea Foot support gussets (D)
You will need a #3 Phillips screwdriver to assemble this Sun Stand™ 2.
Step 1. Place foot over top of outer leg and slide towards bottom.
Step 2. Place a foot support gusset with flat surface out in corner of leg and attach each gusset with
four screws. Then attach the foot to the outer leg with two screws.
Step 3. Repeat step 2 for other side.
STEP 1 STEP 2
A
DETAIL A
STEP 3
Repeat step 2 for
the other side.

Step 4. Slide inner leg into outer leg pulling back the spring
loaded pin to allow it to slide all the way down. Lift inner leg
to set pin into hole.
Step 5. Repeat step 4 for other side leg.
Step 6. Insert both shuttle’s into top by sliding in from under-
neath on the sides.
Step 7. Place top piece over leg assembly and attach using
eight screws.
Step 8. Repeat step 7 for other side.
Step 9. Adjust shuttles to the proper spacing for light by
pushing upwards and sliding into proper stop.
Step 10. Project completed.
STEP 6
A
DETAIL A
STEP 7
DETAIL A
A
STEP 4
PULL THIS PIN OUT
WHILE INSERTING
INTO OUTER LEG
A
DETAIL A
STEP 5
Repeat step 4 for
the other side.
STEP 8
Repeat step 7 for the other side.